User manual PIONEER PDP-S40S

[. . . ] â· When installing the speaker, do not use any screws other than those supplied, otherwise the speaker may come off from the main unit and fall over. Please handle the speaker with sufficient care, as the grille net and the cabinet can become damaged or broken when they are subjected to strong external impacts. â· Placing a CRT computer screen or CRT monitor near to the speaker may result in interference or color distortion. If this happens, distance the monitor from the speaker. [. . . ] To avoid any damage to the speaker and/or table top stand from striking against each other, fit the speaker to the mounting fittings while confirming their locations. As you may easily strike the stand, use the protective wrapping in which the speaker was wrapped between the speaker and stand. â· When the speaker mounting fittings do not fit the grooves at the rear of the speaker, adjust the speaker mounting fittings angle. Tighten from back using the supplied screws (three locations). â· Tighten the three screws in order 1, 2, 3 as shown in the diagram. If you want to move the plasma television, make sure that you remove the speaker first. In addition, do not move the display holding on to the mounting fittings. The screw hole at the bottom surface of the speaker mounting fitting is used when the plasma television is installed on the wall. It is not used when installed with the stand. Speaker mounting screw (M5 x 10 mm) 2 When using the table top stand, do not use these holes. NOTE: If after attaching the speaker its position needs to be adjusted horizontally or vertically, first loosen the speaker mounting screws, reposition and then tighten the screws again at the appropriate position. Connect the cables correctly with respect to the polarity of the plasma television speaker terminals, that is, cable (Gray) to terminals (Red) and cable (Black) to terminals (Black). When you release the lever, it clamps onto the speaker cable. â· Incorrect connections of the speaker cable to the right or left of the plasma television terminals with respect to the polarity may result in insufficient stereo sound effects, delivering poor bass sounds or unstable sound image. Be sure to turn the connected devices off and remove the power cord from the wall outlet beforehand when changing the connection or installation method. â· If you insert the speaker cable too far so that the insulation is touching the speaker terminal, you may not get any sound. Check if the end of the speaker cables are securely connected to the terminals by slightly tugging on the cable after making connections. Loose connections may result in sound dropouts or noise. â· If there is a short in the and cables caused by an exposed lead wire, excessive load may be applied to the plasma television, resulting in interrupted operation or malfunction. Bead bands are included with the plasma television. When tidying up your speaker cables, make sure to bundle them so that they are not subjected to any pressure. When using the hung on wall unit: nOTE: First lay the plasma television on top of a soft sheet etc. [. . . ] NOTE: If after attaching the speaker its position needs to be adjusted horizontally, first loosen the speaker mounting screws, reposition and then tighten the screws again at the appropriate position. NOTE: Specifications and design subject to possible modification without notice, due to improvements. If you want to dispose this product, do not mix it with general household waste. There is a separate collection system for used electronic products in accordance with legislation that requires proper treatment, recovery and recycling. [. . . ]