User manual PIONEER PDP-S50

[. . . ] Placing a CRT computer screen or CRT monitor near to the speaker may result in interference or color distortion. If this happens, distance the monitor from the speaker. about the input ÷ In order to prevent damage to the speaker system resulting from input overload, please observe the following precautions: ÷ Do not use the speaker with anything other than the specified Pioneer Plasma Display. Be sure to turn the connected devices off and remove the power cord from the wall outlet beforehand when changing the connection or installation method. [. . . ] Screw Holes for Air mounting (2 on outside) Speaker Mounting Brackets (For RIGHT-TOP) Speaker Mounting Brackets (For RIGHT- BOTTOM) Place the speaker so its terminals (bottom) are facing you. Place the speaker so its terminals (bottom) are facing you. Use the enclosed padding strips to buffer the speakers when mounting them Flush. Hang the speaker mounting bracket on the screw you installed at the top by passing the wide part over it and lowering into the slot; screw in the lower screw temporarily. After passing the wide part of the hole of the speaker mounting bracket (top) over the screw, lower the speaker onto it. The padding strip should be attached leaving a gap of 10 mm from the top surface of the speaker. After passing the wide part of the hole over the screw, lower the speaker. Screw an enclosed screw into the speaker mounting hole (lower of the two) at the top, back of the display. Leave it loose, with about 5 mm left to tighten. Adjust the position of the speaker and then fix the upper and lower screws firmly. Tighten the two screws, at the top and bottom for each speaker (total of four screws), thus fixing the speakers to the display. Leave a space of about 5 mm To do so, connect the cable with the gray line to the ª terminals and the white cable to the · terminals. Gray line White Gray line Gray line White Push the lever, insert the end of the speaker cable into the hole, and release the lever. Pay attention to the polarity of the speaker terminals when making connections. When you release the lever, it clamps onto the speaker cable. Check if the end of the speaker cables are securely connected to the terminals by slightly tugging on the cable after making connections. Loose connections may result in sound dropouts or noise. If there is a short in the and cables caused by an exposed lead wire, excessive load may be applied to the Plasma Display, resulting in interrupted operation or malfunction. Incorrect connections of the speaker cable to the right or left of the Plasma Display terminals with respect to the polarity may result in insufficient stereo sound effects, delivering poor bass sounds or unstable sound image. Be sure to turn the connected devices off and remove the power cord from the wall outlet beforehand when changing the connection or installation method. [. . . ] If you want to dispose this product, do not mix it with general household waste. There is a separate collection system for used electronic products in accordance with legislation that requires proper treatment, recovery and recycling. Private households in the 25 member states of the EU, in Switzerland and Norway may return their used electronic products free of charge to designated collection facilities or to a retailer (if you purchase a similar new one). For countries not mentioned above, please contact your local authorities for the correct method of disposal. [. . . ]