User manual PIONEER PDP-S51

[. . . ] WARNING: Handling the power cord on this product or cords associated with accessories sold with the product will expose you to lead, a chemical known to the State of California and other governmental entities to cause cancer and birth defects or other reproductive harm. About compatibility This product is designed exclusively for use with the Pioneer Plasma Display. For more information on compatibility, please consult with your nearest Pioneer authorized dealer or service center. See the Operating Instructions packed together with the stand for how to assemble the stand. [. . . ] Adjust the position of the speaker and then fix the upper and lower screws firmly. Adjust the positions of the speakers and the Plasma Display so their top surfaces are the same height. Adjust the positions of the speakers and the Plasma Display so their side surfaces are parallel. Ti ghten the two screws, at the top and bottom for each speaker (total of four screws), thus fixing the speakers to the display. Leave it loose, with about 5 mm left to tighten. Leave a space of about 5 mm Hang the speaker mounting bracket on the screw you installed at the top by passing the wide part over it and lowering into the slot; screw in the lower screw temporarily. After passing the wide part of the hole of the speaker mounting bracket (top) over the screw, lower the speaker onto it. To do so, connect the cable with the gray line to the ª terminals and the white cable to the · terminals. Gray line White Gray line Push the lever, insert the end of the speaker cable into the hole, and release the lever. Pay attention to the polarity of the speaker terminals when making connections. When you release the lever, it clamps onto the speaker cable. Check if the end of the speaker cables are securely connected to the terminals by slightly tugging on the cable after making connections. Loose connections may result in sound dropouts or noise. If there is a short in the and cables caused by an exposed lead wire, excessive load may be applied to the Plasma Display, resulting in interrupted operation or malfunction. Incorrect connections of the speaker cable to the right or left of the Plasma Display terminals with respect to the polarity may result in insufficient stereo sound effects, delivering poor bass sounds or unstable sound image. Be sure to turn the connected devices off and remove the power cord from the wall outlet beforehand when changing the connection or installation method. If you insert the speaker cable too far so that the insulation is touching the speaker terminal, you may not get any sound. Speed clamps are included with the Plasma Display for tidying your cables and keeping extra cable length out of the way. [. . . ] There is a separate collection system for used electronic products in accordance with legislation that requires proper treatment, recovery and recycling. Private households in the 25 member states of the EU, in Switzerland and Norway may return their used electronic products free of charge to designated collection facilities or to a retailer (if you purchase a similar new one). For countries not mentioned above, please contact your local authorities for the correct method of disposal. By doing so you will ensure that your disposed product undergoes the necessary treatment, recovery and recycling and thus prevent potential negative effects on the environment and human health. [. . . ]