User manual PIONEER PDP-V402EA

[. . . ] If you would like to view a video signal with this unit, please make the necessary connections to the optional video card, PDA-4004. About the installation of this product: The Plasma Display is to be installed by a professional with sufficient technical skill. Please have a company specializing in equipment installation or the dealer where you bought your Plasma Display to install it. Our company is not responsible for any damage that may occur as a result of defective installation, wrong use or remodeling of your Plasma Display. [. . . ] Always be sure to work together with another person when unpacking, carrying, or installing the display. 1313-20mm to 20 mm 13 à 20 mm 13 bis 20 mm The display comes with bolt holes for attaching to a wall or other flat surface. When installing fittings or installing the display, always be sure to have the work done by a trained professional or by your dealer. Use bolts (M8) which is to be left by 13 to 20 mm inside the unit when fastened. for installation positions , contact your nearest Pioneer authorized service station. Note that Pioneer bears no responsibility whatsoever for any problems in installation/attachment nor for any accidents or damages caused by natural disasters, etc. Use bolts which are less than 20 mm long inside the unit when fastened. Use of longer bolts will lead to damage of the internal circuit, electrical hazards, fire hazards, etc. 1 This switch will output remote control commands from the RGB-2 (D-SUB 15-pin) terminal to control external peripheral devices planned for future sales release. 2 Switch this according to the output impedance of the sync signal of the device connected when inputting to RGB1. 2 k when the output impedance of the sync signal of the device is other than 75 . 3 To: Personal computers 4 If the images become greenish when an external device is connected to the RGB-2 input terminal, turn ON the G on SYNC mode. 5 To: Personal computers, external RGB decoders, or other devices with RGB output ports 6 To: Personal computers, when controlling the Plasma Display with the personal computer. * In case of a 25-pin RS-232C connecter, use a conversion connector available on your local market. The method of connecting a personal computer to the unit varies with the type of computer. Before connecting the computer, read the instruction manual for the computer also. You can use your Plasma Display together with the computer only in the VGA mode. 5 kHz / Vertical scanning frequency: 75 Hz) 1 G on Sync mode selection switch If the images become greenish when an external device is connected to the RGB-2 input terminal, turn ON the G on SYNC mode. 1 G on Sync mode selection switch If the images become greenish when an external device is connected to the RGB-2 input terminal, turn ON the G on SYNC mode. 2 Computer connecting cable (available on your local market) When inserting the cable, be sure to confirm the shape of the signal input terminal of the Display and that of the connecting cable connector. (How to connect the display to a device which provides green-signal output with the synchronizing signal) 1 G on Sync mode selection switch If the images become greenish when an external device is connected to the RGB-2 input terminal, turn ON the G on SYNC mode. 2 BNC 3B 4G 5R 6 Cable with BNC terminals available on the local market 7 Computer connecting cable If you use your Plasma Display in this way, don't connect any device to its VD or HD terminal. [. . . ] As its ambient temperature changes, the cabinet slightly expands/shrinks and creaks. Apparatus with motors, such as a hair dryer, a vacuum cleaner, and an electric noises. You cannot operate your · the display may not properly operate under external influence , such as lightning or static electricity. In this case, turn off the POWER switch and pull the Plasma Display. [. . . ]