User manual PIONEER PDR-509

[. . . ] This product contains a laser diode of higher class than 1. To ensure continued safety, do not remove any covers or attempt to gain access to the inside of the product. refer all servicing to qualified personnel. The following caution label appears on your Compact Disc Recorder. [. . . ] Make sure that the source is not playing, then press DIGITAL SYNCHRO. Digital synchro recording will not work if the source is already playing!The display shows the 1-track sync mode, with the sync indicator blinking to show that recording can start. Y If you're recording a CD or MD, recording stops automatically when the track changes or there is more than five seconds of silence on the source. Y If you're recording from DCC or DAT tape, recording stops when the recorder encounters a new start ID or there is more than five seconds of silence on the source. To record further tracks, simply repeat steps 3 to 5. Y After pressing 7 (stop), the display shows P M A R E C while it records the track information to the disc. Note: If you find that synchro recording does not seem to work, see the troubleshooting section on page 58 for possible remedies. If you want to copy all the tracks from a CD, MD, DCC or DAT, use this mode. Like the 1-track synchro recording mode, the recorder starts and stops automatically. When recording from MD or CD, you can play the source in either normal play mode, or program play if you'd like the recorded tracks in a different order to the original. We do not recommend recording from a DAT in program play mode--use the 1-track synchro recording mode if you want to record the tracks in a different order. If you are simply duplicating a source disc or tape, you'll probably want to finalize the CD­R (or CD­RW) after all-track sync recording so that it's ready to be played on other CD players. To finalize the disc automatically once recording has finished, see Automatically Recording and Finalizing a Disc on the pages 35, 36. If you're recording from a digital source other than CD, MD, DCC or DAT, see Manually Recording from a Digital Source on pages 37, 38. If you're recording from any source through the analog inputs, see Recording an Analog Source on pages 40, 41. Check the display to make sure that there's enough space on the disc for what you want to record. Make sure that the source is not playing, then press DIGITAL SYNCHRO twice. Digital synchro recording won't work if the source is already playing!The recorder goes into all-sync record pause mode and the S Y N C indicator starts to blink. The display shows the all-track sync mode, with the sync indicator blinking to show that recording can start. After recording all tracks from the source, the recorder goes into all-sync record-pause mode. [. . . ] If you think there is something wrong with the component, check the points below first. If the problem persists, contact you nearest Pioneer-authorized service center and have them check over the unit. Cause ¶ The power cord is unplugged from the wall outlet. ¶ The power was turned off from the component (stereo amplifier, audio timer, etc. [. . . ]