User manual PIONEER PDR-L77

[. . . ] The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. This product contains a laser diode of higher class than 1. To ensure continued safety, do not remove any covers or attempt to gain access to the inside of the product. The following caution label appears on your unit. [. . . ] After recording, always remove the disc from the recorder before switching the power off. Failure to do this could result in you losing some of the recorded material on the disc. Even if you try and record something shorter than this, the track that the recorder creates will be four seconds. Usually, track numbers are recorded onto the disc automatically when recording. If you decide to switch off this feature (for example, when you're recording from a satellite broadcast), be sure to input track markers as recording is taking place--you can't add them after recording is complete. See page 44 for more on manual and automatic track numbering. Use this mode when you want to record just a single track, or a few selected tracks, from a CD, MD, DCC or DAT. The recorder starts and stops automatically, and there's no need to worry about recording levels--you'll get a perfect digital copy of the original (if you want to change the digital recording level, see page 40-41). To record all the tracks on the source, see Recording All Tracks from a Digital Source on page 34-35. To record all the tracks on the source then finalize the disc, see Automatically Recording and Finalizing a Disc on page 36-37. To record from some other digital source, turn to Manually Recording a Digital Source on page 38-39. To record from any source through the analog inputs, see Recording an Analog Source on page 41-42. If the disc isn't blank, use the TIME button to check that there's enough space on it for what you want to record. * This option only appears when the CD recorder is not connected to the XC­L77 CD receiver. See page 43 for more on using the thru input mode. 3 Make sure that the source is not playing, then press DIGITAL SYNCHRO. Digital synchro recording will not work if the source is already playing!The SYNC indicator and play light will start to blink when the recorder is ready. Use the TIME button to switch displays during recording. After a few seconds, the display reverts, showing the recorder is in record-pause mode. If you're recording a CD or MD, recording stops automatically when the track changes or there is more than five seconds of silence on the source. If you're recording from DCC or DAT tape, recording stops when the recorder encounters a new start ID or there is more than five seconds of silence on the source. [. . . ] When the demo mode is on, the demo display will resume if the recorder is idle for about 3 minutes. Page 53 Page 54 Page 53 Page 43 Page 28 Back cover Back cover Below is a list of error messages you may see during playback or recording, with possible causes and remedies. If you need more information, turn to the page indicated. A system error occurred, perhaps due to noise or static electricity. [. . . ]