User manual PIONEER PRS-D3000SPL

[. . . ] Example of installation on the floor mat or on the chassis . Thank you for purchasing this PIONEER product. Before attempting operation, be sure to read this manual. Always use the recommended battery wire and ground wire, which is sold separately. [. . . ] Install and route the separately sold battery wire as far away as possible from the speaker wires. Install and route the separately sold battery wire, ground wire, speaker wires and the amplifier as far away as possible from the antenna, antenna cable and tuner. Cords for this product and those for other products may be different colors even if they have the same function. When connecting this product to another product, refer to the supplied Installation manuals of both products and connect cords that have the same function. Grommet Ground wire (sold separately) The ground wires must be same size as the battery wire. The battery wire, the ground wire and the optional direct ground wire must be same size. After making all other connections at the amplifier, connect the battery wire terminal of the amplifier to the positive (+) terminal of the battery. Optional direct ground wire (sold separately) When chassis grounding is not sufficient, direct grounding should be used. The wire size should be same size as the battery wire. The female terminal can be connected to the auto-antenna relay control terminal. If the car stereo does not have a system remote control terminal, connect the male terminal to the power terminal through the ignition switch. Always use the recommended battery and ground wire, which is sold separately. The battery wire, the ground wire and the optional direct ground wire must be same size. Expose the end of the battery wire and ground wire using nippers or a cutter by about 15­20 mm and twist. Fix the wires securely with the terminal screws. Pass the battery wire from the engine compartment to the interior of the vehicle. After making all other connections to the amplifier, connect the battery wire terminal of the amplifier to the positive (+) terminal of the battery. Failure to securely fasten the battery wire to the terminal using the terminal screws could cause the terminal area to overheat and could result in damage and injury including minor burns. Put the wire ties in the slits and wrap the wire ties around the wires. Wrap the wire tie around the wire insulation, not the stripped wire. Fix the speaker wires securely with the terminal screws. Expose the end of the speaker wires using nippers or a cutter by about 10 mm and twist. [. . . ] If any parts other than the supplied ones are used, they may damage internal parts of the amplifier, or they may become loose causing the amplifier to shut down. Never replace the fuse with one of greater value or rating than the original fuse. Use of an improper fuse could result in overheating and smoke and could cause damage to the product and injury including burns. Become hot to the touch and minor burns could result. [. . . ]