User manual PIONEER S-DJ08

[. . . ] To prevent a fire hazard, do not place any naked flame sources (such as a lighted candle) on the equipment. Do not pull out the plug by tugging the cord and never touch the power cord when your hands are wet as this could cause a short circuit or electric shock. Do not place the unit, a piece of furniture, etc. , on the power cord , or pinch the cord. [. . . ] To produce optimum listening conditions, take due consideration of the conditions of your installation location before beginning actual installation. To promote proper cooling, please assure that sufficient space is preserved between the speakers and nearby walls or other components (minimum 30 cm or more above, behind, and to right and left sides of each speaker). Leaving insufficient space between the speaker and walls or other components may lead to rising interior temperatures, leading to malfunction or damage. For natural stereo effect, the right and left speakers should be installed in symmetrical and equidistant positions from the listening position. Speakers should ideally be located at 30° angles from the listening position (together forming a total 60° angle), and rotated inward to face the listening position. To promote proper cooling, speakers should be separated 30 cm or more from walls. Locating the speakers too close to walls could also cause a disruption of the speakers' frequency response. M5 tapping screw, depth 13 mm (S-DJ05) M8 tapping screw, depth 13 mm (S-DJ08) 60 mm (S-DJ05) 150 mm (S-DJ08) * Illustration depicts the S-DJ08 model. These speakers are provided with no accessory speaker stands, mounting fixtures, or screws. If such facilities are desired, please provide your own as required. As shown in the accompanying illustration, two screw holes are provided on the bottom of each speaker to allow attachment to speaker mounting fixtures. When using such a mounting fixture, consult the usage instructions provided with the fixture and be sure it is capable of supporting the weight of the speaker. An improperly supported speaker could fall, causing serious damage or personal injury. Pioneer accepts no responsibility for any damages or other issues arising from the use of speaker mounting fixtures, including mistaken or insufficient assembly, improper installation, insufficient ability to support speaker weight, misuse, modification, or accidents. Take proper precautions when tightening. Rubber feet The provided rubber feet may be used in accordance with the needs of the installation. Attach one rubber foot to each corner of the bottom of the speaker. Note that insufficient slip-resistance may be provided by the rubber feet in some locations, so they should not be used on slippery surfaces. Never attempt to attach the rubber feet while holding the speaker in a tilted attitude. Place a soft cloth or blanket on the floor, and lay the speaker on its side when attaching the feet. During clipping : flashes or lights steadily pink. If the amplifier generates signal clipping, this indicator flashes (or lights steadily) pink. [. . . ] When connecting the controller, set the controller's LEVEL dial fully counterclockwise to the MIN position, then adjust the sound level as desired after the connection is complete. If the connection is performed when the controller's LEVEL dial is at a high setting, an unexpected loud sound could be emitted from the speaker. If the controller is connected to one speaker's CONTROL IN connector, use the Link cable to connect that speaker's CONTROL OUT connector to the other speaker's CONTROL IN connector. To set the equalizer to ON, press the controller's MUTE/EQ button and hold depressed for one second or more, or else press the EQ ON/OFF button on the rear panel of the speaker. [. . . ]