User manual PIONEER S-DJ50X-W

[. . . ] Do not place the unit, a piece of furniture, etc. Never make a knot in the cord or tie it with other cords. The power cords should be routed such that they are not likely to be stepped on. A damaged power cord can cause a fire or give you an electrical shock. [. . . ] 2 HF LEVEL ADJ dial 1 2 3 4 5 6 7 8 9 a Use to adjust high-frequency sounds. You can select from –2 dB, –1 dB, 0 dB, and 1 dB. 3 AUTO STANDBY switch Use to turn the auto standby function on or off. When the auto standby function is turned on, the speakers automatically enter standby mode if no input signal is received for a certain period of time (approximately 25 minutes) and power consumption can be reduced. When an input signal is received while the speakers are in standby mode, the speakers will automatically resume from standby mode. € The illumination (POWER indicator) on the front panel turns off when the speakers enter standby mode. € When the input signal is weaker than a certain level, the speakers may not automatically resume from standby mode. In such cases, turn off the [AUTO STANDBY] switch to use the speakers. € To force the speakers to resume from standby mode, turn off the [POWER] switch on the rear panel once, and turn it back on after a few seconds. CAUTION Do not connect to both the XLR INPUT connector and the TRS INPUT jack at the same time. CAUTION Before turning on the power, make sure to check that the [VOLTAGE SELECTOR] switch is set to the appropriate voltage for the country or region where the speakers will be used. If the [VOLTAGE SELECTOR] switch is not correctly set, contact a Pioneer service center and request that the set voltage be changed and the fuse be replaced. At the time of shipment, a fuse with the appropriate voltage setting is set in the product. When it becomes necessary to change the voltage setting, the fuse must be replaced. 8 VOLTAGE SELECTOR switch This switch is used to select the appropriate voltage settings for the country/region of use. It is not to be used by the customer directly. 9 AC IN Connect the accessory power cord here and to an AC power outlet. Do not plug in the power cord until all other connections have been completed. Use only the furnished accessory power cord. A Fuse holder 4 En DRC1402-A 4 English Installation and Connections How to Install A speaker’s playback sound is delicately influenced by conditions in the listening room. To produce optimum listening conditions, take due consideration of the conditions of your installation location before beginning actual installation. 50 °～ 60 °  Speakers should ideally be located at 30 ° angles from the listening position (together forming a total 60 ° angle), and rotated inward to face the listening position. [. . . ] illumination (POWER indicator) remains turned off. Speakers do not resume (turn on) from Is the level of the input signal low?Is the output level of the connected audio device set Adjust the output level of the connected audio device properly?Slowly turn the [LEVEL] dial on the rear panel counterclockwise and turn down the volume. [. . . ]