User manual PIONEER S-J310V

[. . . ] 3 Pay close attention to all warnings in this manual and follow the instructions carefully. 4 Do not allow other persons to use this system until they have read and understood the operating instructions. 5 Do not install the display where it may (i) obstruct the driver's vision, (ii) impair the performance of any of the vehicle's operating systems or safety features, including air bags, hazard lamp buttons or (iii) impair the driver's ability to safely operate the vehicle. 6 Do not operate this display if doing so in any way will divert your attention from the safe operation of your vehicle. [. . . ] You cannot use this function if auto EQ has not been carried out. Graphic EQ (equalizer adjustment) You can adjust the currently selected equalizer curve setting as desired. Adjusted equalizer curve settings are stored in Custom1 or Custom2. A separate Custom1 curve can be created for each source. If you make adjustments when a curve other than Custom2 is selected, the equalizer curve settings will be stored in Custom1. A Custom2 curve that is common for all sources can be created. If you make adjustments when the Custom2 curve is selected, the Custom2 curve will be updated. Powerful--Natural--Vocal--Custom1--Custom2--Flat--Super Bass 3 Push M. C. left or right to select the equalizer band to adjust. 40Hz--80Hz--200Hz--400Hz--1kHz--2. 5kHz --8kHz--10kHz 4 Push M. C. up or down to adjust the level of the equalizer band. Only frequencies higher than those in the selected range are output from the front or rear speakers. Off (off)--50Hz--63Hz--80Hz--100Hz--125Hz 3 Press M. C. SLA (source level adjustment) SLA (Source level adjustment) lets you adjust the volume level of each source to prevent radical changes in volume when switching between sources. When selecting FM as the source, you cannot switch to SLA. Settings are based on the FM volume level, which remains unchanged. The MW/LW volume level can also be adjusted with this function. Adjustment range: +4 to ­4 Operating this unit Note You cannot select Custom1 and Custom2 when using the auto-equalizer. En 29 Section 03 Operating this unit Entertainment settings 1 Display the entertainment menu. Refer to Basic menu operations on page 9. After selecting, perform the following procedures to set the entertainment function. Background (background display setting) 1 Press M. C. BGP1 (background picture 1)--BGP2 (background picture 2)--BGP3 (background picture 3) --BGV (background visual)--Photo (photo)-- SPEANA (spectrum analyzer)--Off (display off) 3 Press M. C. Clock (entertainment clock) 1 Press M. C. [. . . ] MPEG-1 & 2 Audio Layer 3 WMA decoding format . . . . . . . . . 7, 7. 1, 8, 9, 10, 11, 12 (2 ch audio) (Windows Media Player) AAC decoding format . . . . . . . . . . . . 9. 0. 3 and earlier) DivX decoding format . . . . . . . . . . . . 3, 4, 5. 2, 6 (. avi, . divx) Note Specifications and the design are subject to modifications without notice. SD Compatible physical format . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]