User manual PIONEER S-J320V

[. . . ] To avoid the risk of accident and the potential violation of applicable laws, no viewing of front seat video should ever occur while the vehicle is being driven. Also, rear displays should not be in a location where they are visibly distracting to the driver. In some countries or states the viewing of images on a display inside a vehicle even by persons other than the driver may be illegal. Where such regulations apply, they must be obeyed and this unit's DVD features should not be used. [. . . ] The MW/LW volume level can also be adjusted with this function. Video CD, CD, compressed audio and DivX are automatically set to the same source level adjustment volume. Adjustment range: +4 to ­4 3 Press M. C. to confirm the selection. 22 En Section Operating this unit Setting up the DVD player Introduction of DVD setup adjustments You can use this menu to change audio, subtitle, parental lock and other DVD settings. To perform this function, set the remote control to DVD mode. 1 Select DVD as the source and then press g. 3 Move the thumb pad left or right to switch the DVD setup menu categories. (general) 4 Move the thumb pad up or down to select the DVD setup function names. (subtitle language settings)--AUDIO LANG. (menu language settings) --OSD LANGUAGE (on screen display language setting)--CHARACTER SET (character set setting) For PICT. : ANGLE ICON DISPLAY (angle icon)-- TV ASPECT (TV aspect)--SLIDESHOW TIME (slideshow interval time setting) For GEN. : PARENTAL (parental lock)--DivX SUBTITLE (DivX subtitle)--IEC DIGITAL OUTPUT (digital output setting)--DivX VOD (DivX VOD)-- SAMPLING OUTPUT (down sampling output setting) If you press MENU during display of a DVD setup menu, the DVD setup menu is canceled and the unit returns to the previous display. 02 Setting the subtitle language You can set a desired subtitle language. When available, the subtitles will be displayed in the selected language. 1 Move the thumb pad up or down to select ANGLE ICON DISPLAY in PICT. 2 Click the thumb pad to select on or off. A character set setting menu is displayed. Notes !If the selected language is not available, the language specified on the disc is displayed. If you have selected OTHERS, refer to When you select OTHERS on the previous page. Setting the aspect ratio There are two kinds of display: a wide screen display that has a width-to-height ratio (TV aspect ratio) of 16:9, and regular display that has a TV aspect of 4:3. Be sure to select the correct TV aspect for the display connected to V OUT. When using regular display, select either LETTER BOX or PANSCAN. Selecting 16:9 may result in an unnatural picture. If you select the TV aspect ratio, the unit's display will change to the same setting. 1 Move the thumb pad up or down to select TV ASPECT in PICT. 3 Move the thumb pad up or down to select the desired TV aspect. [. . . ] ±12 dB Treble Frequency . . . . . . . . . . . . . . . . 10 kHz Gain . . . . . . . . . . . . . . . . . . . . . . . . . . . . ±12 dB FM tuner Frequency range . . . . . . . . . . . . . . . . . . . . . . 87. 5 MHz to 108. 0 MHz Usable sensitivity . . . . . . . . . . . . . . . . . . . . . [. . . ]