User manual PIONEER TS-W307F

[. . . ] If the plug contains a removable fuse cover, you must ensure that it is refitted when the fuse is replaced. If you lose the fuse cover the plug must not be used until a replacement cover is obtained. A replacement fuse cover can be obtained from your local dealer. If the fitted moulded plug is unsuitable for your socket outlet, then the fuse shall be removed and the plug cut off and disposed of safely. [. . . ] 2 When listening to 2-channel sources in DOLBY PLIIx MUSIC mode, there are three further parameters you can adjust: C. 3 When listening to 2-channel sources in NEO:6 CINEMA or NEO:6 MUSIC mode, you can also adjust the C. Listening to your system When you select STEREO you will hear the source through just the front left and right speakers (and possibly your subwoofer depending on your speaker settings). ), this unit equalizes playback sound levels if each sound level varies with the music source recorded in a portable audio player. The Front Stage Surround Advance function allows you to create natural surround sound effects using just the front speakers and the subwoofer. STEREO ­ The audio is heard with your surround settings and you can still use the Midnight, Loudness, Phase Control, Sound Retriever and Tone functions. ADVANCE ­ See Using Front Stage Surround Advance below for more on this. STEREO ­ See Listening in stereo above for more on this. ­ See Listening in stereo above for more on this. ADVANCE ­ Use to provide a rich surround sound effect directed to the center of where the front left and right speakers sound projection area converges. Listening to your system Use the Stream Direct modes when you want to hear the truest possible reproduction of a source. Press RECEIVER, then press SB CH repeatedly to cycle the surround back channel options. Each press cycles through the options as follows: · sB CH ON ­ Matrix decoding processing for Generating the surround back component from the surround component is turned on. SB CH AUTO ­ Matrix decoding processing for generating the surround back component from the surround component is switched automatically. Matrix decoding processing is only performed when surround back channel signals are detected in the input signals. ⷠSB CH OFF ­ Matrix decoding processing for generating the surround back component from the surround component is turned off. 2 While holding down the PRESET + on the front panel, and hold the STANDBY/ON for about two seconds. uP MIX: OFF appears and the Up Mix function turns off. If you want to turn this function on, perform steps 1 and 2 again. ⷠWhen set to ON, the UP MIX indicator on the front panel lights. Set to ON regardless of this setting when playing DTS-HD signals. ⷠMay automatically be set to OFF even when set to ON, depending on the input signal and listening mode. [. . . ] 2 While holding down the `TUNE +' button, press and hold the STANDBY/ON button for about two seconds. The display shows the new setting (PAL or NTSC). Use this procedure to reset all the receiver's settings to the factory default. Use the front panel controls to do this. [. . . ]