User manual PIONEER TX-220ZL

[. . . ] The current capacity of the lead will be exceeded, causing overheating. · When replacing fuse, be sure to use only fuse of the rating prescribed on the fuse holder. · If the RCA pin jack on the unit will not be used, do not remove the caps attached to the end of the connector. [. . . ] Connect the connectors of the same colors correctly. · If this unit is installed in a vehicle that does not have an ACC (accessory) position on the ignition switch, the red lead of the unit should be connected to a terminal coupled with ignition switch ON/OFF operations. If this is not done, the vehicle battery may be drained when you are away from the vehicle for several hours. (Fig. 1) ACC <ENGLISH> When Connecting the Multi-Channel AV Master Unit Multi-Channel AV Master Unit (e. g. AVM-P9000) (sold separately) INSTALLATION MANUAL INSTALLATION MANUAL TX-220ZL Green OF OF F O F O ACC position No ACC position · Cords for this product and those for other products may be different colors even if they have the same function. When connecting this product to another product, refer to the supplied Installation manuals of both products and connect cords that have the same function. This product conforms to new cord colors. Printed in Japan <CRB1740-A> ES/RD <KNKZF/01D00000> T N STAR N Multi-CD player (sold separately) STAR T Fig. 1 Yellow Blue Blue IP-BUS cable (supplied with the TV tuner) Optical cable (supplied with the MultiChannel AV Master Unit) Blue This product Black Blue 40 cm FM MODULATOR IP-BUS MAIN UNIT IP-BUS AV MASTER RCA cable (sold separately) Hide-away TV Tuner (e. g. GEX-P7000TV) (sold separately) Black RCA cable (supplied) 6m 40 cm Not used. 16 cm Yellow (AVM OUTPUT) Green Red 20 pin cable (supplied with the TV tuner) Gray AV cable (supplied with the Multi-Channel AV Master Unit) IP-BUS cable (supplied with the Multi-Channel AV Master Unit) Blue Gray Green 3m 20 pin cable (supplied) Red Fig. · If installation angle exceeds 30° from horizontal, the unit might not give its optimum performance. 6) <ENGLISH> DIN Front/Rear-mount This unit can be properly installed either from "Front" (conventional DIN Front-mount) or "Rear" (DIN Rear-mount installation, utilizing threaded screw holes at the sides of unit chassis). For details, refer to the following illustrated installation methods. 2. 8) 7 When the installation space is not very deep When installing in a shallow space, secure with side brackets (small). In this case, stick conceal tape on parts that protrude from the dashboard. Holder After inserting the holder into the dashboard, then select the appropriate tabs according to the thickness of the dashboard material and bend them. (Install as firmly as possible using the top and bottom tabs. To secure, bend the tabs 90 degrees. ) Rubber bush Screw Conceal tape Attach screw Holder After inserting the holder into the dashboard, then select the appropriate tabs according to the thickness of the dashboard material and bend them. (Install as firmly as possible using the top and bottom tabs. To secure, bend the tabs 90 degrees. ) Rubber bush Screw DIN Front-mount Side bracket 30° Dashboard 182 Installation with the rubber bush 1. [. . . ] To secure, bend the tabs 90 degrees. ) Rubber bush Screw DIN Front-mount Side bracket 30° Dashboard 182 Installation with the rubber bush 1. 6 Frame Flush surface screw (5 × 6 mm) 53 Fig. (When reattaching the frame, point the side with a groove downwards and attach it. ) As a rule, secure with side brackets (large). Dashboard Side bracket (small) Fig. [. . . ]