User manual PIONEER VMS-550

[. . . ] Eu English: Hereby, Pioneer, declares that this VMS-550 is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. To prevent a fire or shock hazard, do not place any container filled with liquid near this equipment (such as a vase or flower pot) or expose it to dripping, splashing, rain or moisture. D3-4-2-1-3_A1_En WARNING To prevent a fire hazard, do not place any naked flame sources (such as a lit candle) on the equipment. D3-4-2-1-7a_A1_En Operating Environment Operating environment temperature and humidity: +5 °C to +35 °C (+41 °F to +95 °F); less than 85 %RH (cooling vents not blocked) Do not install this unit in a poorly ventilated area, or in locations exposed to high humidity or direct sunlight (or strong artificial light) D3-4-2-1-7c*_A1_En When using this product, confirm the safety information shown on the bottom of the unit. [. . . ] Do not use other types of rechargeable or dry-cell batteries. € Rechargeable batteries should be replaced with new ones when they last only a short time after recharging. New batteries can be ordered from your nearest Pioneer authorized service centre. € During recharging, sound is not produced from the speaker even if the speaker’s power switch is turned on. € The speaker’s POWER indicator normally lights green during use, but when the battery’s remaining charge is low, the indicator flashes green. If the indicator begins flashing, the speaker should be recharged as soon as possible. € If the speaker is only used for short periods of time, the battery should not be recharged until it is allowed to discharge completely. If the battery still allows only a short operating time after full recharging, the battery may have reached the end of its lifetime. English Français Español Deutsch Italiano Nederlands 2-3 Connecting up By connecting this unit to a television or AV component, you can listen to the TV/ AV component’s sound through this unit’s speakers. For details regarding connections, read the TV/AV component’s operating instructions. 1 Listening to audio using only this unit’s speakers Connect the headphone output jack of the TV/AV component to the transmitter’s input cord (see Figure 2-3. Sound will cease to be output from the TV/AV component and will be output from this unit’s speakers alone. Pyccкий Note • If this unit is connected to Mono TV, sound will be produced from the unit’s left speaker only. € If the TV/AV component’s controls are used to adjust the sound volume, the sound volume from the speakers will change. If the volume is raised to an excessive level in this way, sound from the speakers may be distorted. In this case, first lower the volume using the TV/AV component controls, then raise the volume by using the speaker’s controls. 7 En • Depending on the TV/AV component used, sound may continue to be produced from its speakers even after connecting this unit to its headphone output jack. 2 Listening to audio using the speakers of both this unit and those of the TV/AV component Using the accessory conversion cord, connect the line output jacks of the TV/ AV component to the transmitter’s input cord (consult Figure 2-3. Note • When connecting the conversion cord to the TV/AV component, be sure to match the colors (red and white) of the line output jacks. € The method described here cannot be used if the TV has no line output jacks. In this case, consult the section “Listening to audio using only this unit’s speakers”. Operation 3-1 Using the system 1 Connect the supplied AC adaptor to DC IN jack on the transmitter. [. . . ] € Check the terminals of the rechargeable battery and confirm that they are clean. € Check whether the charging contacts are soiled, and clean with a cotton swab if necessary. € Confirm that the rechargeable batteries have been installed with the +/– polarities in the correct orientation. English Français The batteries will not charge. [. . . ]