User manual PIONEER VSW-1

[. . . ] Thank you for buying this Pioneer product. Please read through these operating instructions so you will know how to operate your model properly. After you have finished reading the instructions, put them away in a safe place for future reference. In some countries or regions, the shape of the power plug and power outlet may sometimes differ from that shown in the explanatory drawings. [. . . ] Since the power cord serves as the main disconnect device for the unit, you will need to unplug it from the AC outlet to shut down all power. Therefore, make sure the unit has been installed so that the power cord can be easily unplugged from the AC outlet in case of an accident. To avoid fire hazard, the power cord should also be unplugged from the AC outlet when left unused for a long period of time (for example, when D3-4-2-2-2a_A_En on vacation). When using this product follow the instructions written on the underside of the unit, which D3-4-2-2-4_En concern rated voltage, etc. Using the latest circuit technology, this unit suppresses noises and color distortion even during sudden switchovers. Can be combined with a Pioneer DJ mixer for video switching linked to the fader start mode. ¶ Do not install above an amplifier or other heat-emitting component, or use for long periods near spotlights or other heademitting appliances, since the unit may suffer adverse effects. ¶ Install away from tuners and television sets. When placed near such components, noise and video distortion may occur; such effects are particularly subject to occurrence when an internal antenna is used; in such cases, either use an external antenna, or turn off this unit's power. ¶ The screws on the right and left sides of this unit can be used to mount the unit in a rack installation or stand. Note: When installing the unit in a rack or stand, always use the screw holes provided on the right and left sides of the unit. 1 For improvement purposes, specifications and design may be subject to modification without notice. Use a polishing cloth to wipe off dust and dirt. 㷠When the surfaces are very dirty, wipe with a soft cloth dipped in some neutral cleanser diluted five or six times with water and wrung out well, then wipe again with a dry cloth. Never use thinners, benzene, insecticide sprays or other chemicals on or near this unit, since these will corrode the surfaces. Use to connect this unit to player B (DVJ-X1). Player control connector, used to control player, fader start and other operations (minijack x 1). Use the control cable (provided with DVJ-X1) to connect to player A's CONTROL connector. Use video cable (provided with DVJ-X1) to connect to player B's VIDEO OUT connector. The sync signal is used to synchronize video signals between players A and B, thus preventing video distortion resulting from mix-matched signals when switching between images. Use the BNC plug coaxial cable (furnished with this unit) to connect to player A's SYNC IN connector. Use a S-Video cable (sold separately) to connect to the player B's SVideo VIDEO OUT connector. [. . . ] Whenever power is first turned on, PLAYER A input is selected by default. ¶ If the VIDEO B button is pressed while holding the VIDEO A button depressed, PLAYER B input is selected; when the VIDEO B button is then released, input returns immediately to PLAYER A, thus allowing quick switching between A/B inputs. The indicator around the border of the VIDEO B button lights when PLAYER B input has been selected. Incorrect operations are often mistaken for trouble and malfunctions. [. . . ]