User manual PIONEER VSX-D811S-K

[. . . ] Thank you for buying this Pioneer product. Please read through these operating instructions so you will know how to operate your model properly. After you have finished reading the instructions, put them away in a safe place for future reference. Make sure to leave space around the unit for ventilation to improve heat radiation (at least 60 cm at top, 10 cm at rear, and 30 cm at each side). [. . . ] The current setting is shown for each option as you cycle through the display. Speaker setting (page 68) Specify the number and type of speakers you have connected. Surround back speaker setting (VSXD811S only) (page 69) Specify your surround back speaker/ surround back subwoofer setup. Crossover frequency setting (page 70) Determine which frequencies will be sent to the subwoofer (or large speakers). lFE attenuator setting (page 71) Specify the peak level for the LFE channel. Front speaker distance setting (page 71) Specify the distance from your listening position to your front speakers. Center speaker distance setting (page 72) Specifies the distance from your listening position to your center speaker. Surround speaker distance setting (page 72) Specify the distance from your listening position to your surround speakers. Surround back speaker distance setting (VSX-D811S only) (page 73) Specifies the distance from your listening position to your surround back speakers. Dual mono setting (page 74) Isolate one channel when listening to discs with dual mono encoding. Surround back channel input setting (VSX-D811S only) (page 75) Specify the number of surround back inputs you have connected. The setting display is automatically exited after 20 seconds of inactivity. Default setting: S (all speakers) You must let the receiver know how many speakers you have, and how big they are. The size you choose (large or small) determines how much bass is sent from the receiver to the speakers. In the display, F, C, and S refer to front, center, and surround speakers respectively. Speaker size is denoted as L for large speakers, S for small speakers, and (asterisk) if no speaker is connected. If the cone size (diameter) of the speaker is larger than 15 cm, set the speaker size to L. If you're not using a subwoofer, we recommend setting the front speakers to L. Cycle through the available choices using ' or ` and choose a configuration that matches your speaker setup. One of the following configurations should match your setup: · Default setting: S You must let the receiver know if surround back speaker(s) have been connected, and how big The size you choose (large or small) determines how much bass is sent from the receiver to the speakers. If you have connected a surround back subwoofer, you should select the surround back subwoofer setting (SB SUBWF) from the options. 1 AUTO), or you can choose to listen to other kinds of sources (for example, 5. [. . . ] If the trouble cannot be rectified even after exercising the checks listed below, ask your nearest Pioneer authorized service center or your dealer to carry out repair work. remedy · Connect the power plug to the wall outlet. Disconnect the power plug from the outlet, and insert again. Make sure there are no loose strands of speaker wire touching the rear panel. [. . . ]