User manual PIONEER VSX-D859TX

[. . . ] The plug or adaptor or the distribution panel should be provided with 5 A fuse. As the colours of the wires in the mains lead of this appliance may not correspond with coloured markings identifying the terminals in your plug, proceed as follows ; The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black. The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red. Do not connect either wire to the earth terminal of a three pin plug. [. . . ] Default setting: AUTO You need to hook up a component to both analog and digital inputs on the rear of the receiver to select between input signals. Each press cycles through the options as follows: · Listening to your system 1 encoded sources (for example, Dolby Digital EX or DTS-ES), or you can choose to always use 6. 1 decoding with other sources (for example, 5. 1 encoded sources, a surround back channel will be generated, but the material may sound better in the 5. 1 format for which it was originally encoded, in which case you can simply switch the surround back channel off. The table below indicates when you will hear the surround back channel. Each press cycles through the options as follows: 1 encoding is always used (for example, on 5. 1 encoded material) · SB CH OFF ­ Surround back channel is switched off You can't use the surround back channel with headphones, the STEREO / DIRECT mode, or if the Surround back speaker setting on page 43 is set to SB or (VSXD814 only) SB SW. ⷠYou can't hear the surround back channel with DTS 96kHz/24 bit sources. Listening to your system Selecting this mode allows you to hear a virtual back channel through your surround speakers. For example, you can choose to listen to sources with no surround back channel information (for example, 5. If you have connected a decoder or a DVD player with multichannel analog outputs to this receiver (page 18), you must select the analog multichannel inputs for surround sound playback. You can check the remaining sleep time at any time by pressing SLEEP once. Pressing repeatedly will cycle through the sleep options again. ⷠYou can also switch off the sleep timer simply by switching off the receiver. To cancel playback from the multichannel inputs, use the SIGNAL SELECT button to select a different input signal. To ensure the best possible surround sound, be sure to complete the following set up operations. This is particularly important when using DTS and Dolby surround. You only need to make these settings once (unless you change the placement of your current speaker system or add new speakers, etc. Refer to the following pages for details on each of the settings. Speaker setting (page 42) Specify the number and type of speakers you have connected. Surround back speaker setting (page 43) Specify your surround back speaker/ surround back subwoofer setup. [. . . ] ⷠMove antennas farther away from equipment causing the noise. No sound from surround or center speakers. Refer to Manually calibrating your listening area (MCACC) on page 48 (with the VSX-D814, you can do this using the Quick surround sound setup on page 13) to check the speaker levels. Refer to Surround back speaker setting on page 43 to check the surround back speaker settings. [. . . ]