User manual PIONEER XC-L5

[. . . ] These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ­ Reorient or relocate the receiving antenna. [. . . ] 5 Play light ­ Lights when a CD is playing 6 Standby/On button ­ Press to switch the unit between standby and on modes. Note: this unit consumes a small amount of electricity in standby mode (1 W). 7 Phones socket ­ Connect a pair of headphones for private listening. When plugged in, the speakers are automatically switched off. 2 SOUND ­ Press to put the $ and > buttons into tone, subwoofer level and balance control mode. Also use to select characters when naming tuner station memories, etc. 6 & /CANCEL ­ Press to stop playback of the CD. Also use to cancel operations, such as setting the clock, before the SET button has been pressed (see 5 above). 7 $ > buttons ­ Press to fast-reverse / fastforward the CD. 8 CD mode ­ Press to switch the sound to CD and start the disc playing (if there's one loaded). 1 Tuner mode ­ Press to switch the sound to tuner, 1 switch between AM and FM, and switch between preset station memories. 4 Use the $ and > buttons to set the correct year, then press SET. Here, we'll run through the basics you need to play discs in the CD player/receiver. Other features of the CD player, such as programming the track order, are covered later--see pages 29 to 34 for complete instructions on all the CD player's features. Place a CD, with the label face up, on to the disc tray, making sure that it is seated properly in the disc guide. Note: Do not use an adapter when playing 8 cm (3 in. The disc tray closes and the disc starts playing from track 1. You can also use the CD receiver's front panel controls: ^ closes the disc tray and starts the disc playing from the first track. ) closes the disc tray without starting playback. CD playing with the track number and track time elapsed shown in the display. The display indicates the current volume level as you adjust it. You can also use the CD receiver's front panel controls: Press ^ once to pause playback; press again to resume. [. . . ] Power turns off abruptly during operation. Do not install the CD receiver on top of any deep-pile rug, thus blocking the cooling vents. Not all connection cables are connected properly. Refer to the section on connections and make sure all connections are correct and secure. [. . . ]