User manual PIONEER XC-L77

[. . . ] The serial number for this equipment is located on the base. Please write this serial number on your enclosed warranty card and keep it in a secure area. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. [. . . ] This remote control has a feature that will allow you to locate it if you've mislaid it in the room. When REMOTE LOCATOR is switched on, clapping three times within the space of about a second will cause the remote control to beep. Although a useful function, leaving remote locator on all the time reduces the battery life of the remote. for this reason , an on/off slider switch is provided on the rear. When switched on, the remote will sometimes beep if knocked or dropped -- this is not a malfunction. 1 CD function ­ Highlights when in CD player mode 2 Tuner function ­ Highlights when in tuner mode 3 Aux/CD-R function ­ Lights when in aux/CD-R mode 4 Wake up timer ­ Lights when the wake up timer is set; flashes during wake up timer playback. 5 Sleep timer ­ Lights when the sleep timer is set. 8 Mono ­ Lights when the tuner is set to the mono mode (applies only to FM broadcasts). If you've followed the manual to here, you should now have your system installed with everything connected up and plugged in. This chapter takes you through using the basic features: playing CDs, listening to radio stations, and adjusting the volume, tone and balance to get the sound you want. first of all , we'll set the clock. This is mainly used for timer functions, such as the sleep timer, though you can also use the display as a clock. Unless you unplug the unit, or there's a power failure, you only need to set the clock once. You can use the STANDBY/ON button on either the remote control or the CD receiver unit to do this. The display lights and briefly indicates the current volume level before showing the current function (e. Display shows the CD player as the current function (no disc loaded) The display changes to show a date and time, with the day part of the year flashing to indicate that you can set it. Year / month / day Once you've pressed SET, the month will start flashing. After setting the year, set the month Each time you press SET, the next part of the date/time will start flashing. Correct time and date after setting Heure et date correctes après le réglage Remember: If power is interrupted, the clock display will flash until you reset it to the correct time. To use the timer features, always set the clock to the correct time. 4 Use the $ and > buttons to set the correct year, then press SET. Here, we'll run through the basics you need to play discs in the CD player/receiver. [. . . ] To cancel the demo mode, press the power switch on either of the CD receiver or remote control unit while the demo mode is operating. Load discs with label side (printed surface) upwards. Play doesn't start when · Can't listen to broadcasts, or sound is · ), including the fluorescent display of this noise, or move it farther away from the antenna. System, is being used in the near vicinity. [. . . ]