User manual PIONEER XV-HTD510(-B)

[. . . ] RISK OF ELECTRIC SHOCK DO NOT OPEN The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. The use of optical instruments with this product will increase eye hazard. Alteration or modifications carried out without appropriate authorization may invalidate the user's right to operate the equipment. [. . . ] 2) ­ Virtual surround sound if you have connected the surround speakers, but are using them in front of the listening position. OFF) ­ All sources are played through only the front left and right speakers, and the subwoofer. The surround modes cannot be used in combination with DSP effects or with 96kHz digital sources. You cannot change the surround mode when Record Mode is active (see Direct recording on page 40). Each press changes the surround mode as follows: · Listening to other sources with room effects (XV-HTD510 only) You can add room effects to audio CDs and other stereo sources using the DSP modes. Different effects work better with different kinds of music, so don't be afraid to experiment a little. There are seven DSP effects to choose from: · The DSP effects cannot be used in combination with the surround modes or with 96kHz digital sources. When playing stereo sources with DSP effects switched off, there is no sound from the surround and center speakers. You cannot change the DSP mode when Record Mode is active (see Direct recording on page 40). Each press changes the mode as follows: · You can adjust the effect level when using one of the DSP effects or Advanced Theater effects. It is not possible to change the effect level of the AUTO or STANDARD surround mode (or when DSP or Surround modes are off). You cannot change the effect level when Record Mode is active (see Direct recording on page 40). You can adjust the effect level in the range of 10 to 90. Listening at low volume When the volume is low, surround effects tend to become less than satisfactory. Turn the Midnight listening mode on to enjoy quality surround sound even at low volumes. Use the 5 and buttons to turn ON or OFF. You cannot change the Midnight mode when Record mode is active (see Direct recording below). This feature let's you record directly to an external recorder, without worrying about the various sound settings. When the Record mode is on you cannot change or adjust the bass, treble, surround and DSP mode settings or the Midnight setting. Once the power is switched off or the function is changed, the Record mode automatically reverts to off. To switch off the Record mode, repeat the same proceedure. In step 3 above the display shows Most of the functions covered in this chapter apply to DVD discs, Video CDs and CDs, although the exact operation of some varies slightly with the kind of disc loaded. [. . . ] Picture disturbance during playback or screen is dark. If the radio signal is weak, an outdoor antenna will usually give better results than the supplied indoor types. Other electrical equipment, such as TVs, fluorescent lamps and motors can cause interference. Try switching off or moving the equipment, or moving the antenna(s). [. . . ]