User manual PIONEER XW-HTD525

[. . . ] RISK OF ELECTRIC SHOCK DO NOT OPEN The lightning flash with arrowhead, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. To prevent a fire or shock hazard, do not place any container filed with liquid near this equipment (such as a vase or flower pot) or expose it to dripping, splashing, rain D3-4-2-1-3_A_En or moisture. Before plugging in for the first time, read the following section carefully. The voltage of the available power supply differs according to country or region. [. . . ] For the best stereo effect, place the front speakers 2­3 m apart, at equal distance from the TV. For best surround sound, make sure to place the wireless speaker directly behind the center of the listening position and no higher than ear level. Install the center speaker above or below the TV so that the sound of the center channel is localized at the TV screen. To compensate for channel delay with this system, you should adjust the surround speaker distance setting in Choosing your receiver setup (in the receiver manual) so that it is equal to the front speaker distance setting. If you choose to install the center speaker on top of the TV, be sure to secure it by suitable means to reduce the risk of damage or injury resulting from the speaker falling from the TV in the event of external shocks such as earthquakes. Make sure that all speakers are securely installed. This not only improves sound quality, but also reduces the risk of damage or injury resulting from speakers being knocked over or falling in the event of external shocks such as earthquakes. 2 CHANNEL In case of poor reception due to interference from other electrical devices, you can improve reception by selecting another channel. Each time you press the button, the channel changes sequentially: 7 STEREO MODE VOLUME Turn to adjust the speaker volume when the WIRELESS MODE is set to W. 9 TUNED indicator Lights when the signal from the transmitter is properly received. Poor reception may cause the audio to be interrupted or stopped. The wireless speaker can be used at distances of up to 10m from the transmitter. This range may change depending on the environment. SURROUND - Sounds going to the surround left and right channels are heard through the wireless speakers. SURROUND is selected, you can control the level of the wireless speaker by adjusting the LS and RS channel levels as necessary for balanced surround sound. [VSX-C402] Refer to the section on Setting individual channel level in the receiver's operating instructions. [VSX-D514] Refer to the section on Setting the relative volume level of each channel in the receiver's operating instructions. [VSX-D514 only] You can also use the signal converter AUDIO LEVEL control to adjust the wireless speaker volume. STEREO - The wireless speaker can be used as a second stereo speaker system (which will output the same stereo signal as the main system) when you use this setting with the 5-STEREO mode on the receiver. You will be able to adjust the sound of this speaker independently using the STEREO MODE VOLUME control (see below). When setting up the receiver, make sure the surround speakers are set to S(small). Settings larger than S will result in lower frequency distortion in sources that have a lot of bass. [. . . ] Heat may be generated which could lead to fire. Consult with the retailer or an electrician regarding replacement of the power outlet. Some baby monitors Other, less common, equipment that may operate on the same frequency: · The radio waves received by the receiver include the radio wave coming directly from the transmitter (direct wave) and waves coming from various directions due to reflections by walls, furniture and building (reflected waves). The reflected waves (due to obstacles and reflecting objects) further produce a variety of reflected waves as well as variation in reception condition depending on locations. [. . . ]