User manual PITSOS DIF5505

[. . . ] HQ 2SHUDWLQJ LQVWUXFWLRQV 9000 538 939 (9009) 'LVKZDVKHU en Table of contents Washing the dishes . Protection against frost (Emptying the appliance) . 15 15 15 15 15 16 16 16 16 16 16 17 17 17 17 18 18 19 19 19 20 20 21 22 22 22 23 23 23 23 24 24 24 24 25 25 25 Safety instructions . 7 Switching off water softening system . [. . . ] ­ Press the timer programming button until the digital display ` jumps to . ­ Keep pressing the timer programming button until the required time is displayed. ­ To delete the preselected starting time, press the button until is indicated on the digital display `. You can change your programme selection at any time until the programme starts. Switching on the appliance ­ Turn on the tap fully. ­ Rotate programme selector 8 to the required programme. The expected programme duration is indicated on the numerical display `. ­ The programme starts running. Remaining running time display When the programme is selected, the remaining running time of the programme is indicated on the digital display `. The running time is determined during the programme by the water temperature, the number of utensils as well as the degree of soiling and may vary (depending on the selected programme). 15 en End of programme The programme has ended when the value is indicated on the numerical display `. Changing the programme After you have switched the appliance on, it is possible to change the programme within 2 min. If you want to change the programme afterwards, the appliance waits until the initiated programme section (e. The remaining time comprises the remaining time of the previous programme section and the remaining time of the new selected programme. Switching off the appliance Short time after the end of the programme: ­ Switch off the main switch (. ­ Turn off the tap (not applicable if AquaStop fitted). ­ Remove the utensils when they have cooled down. Intensive drying The final rinse uses a higher temperature which improves the drying result. (Caution if utensils are delicate!) ­ Close the door. ­ Hold down button + and press main switch ( until the digital display illuminates. The factory-set value (off) or (on) is lit on the digital display `. To change the setting: ­ By pressing the button +, you can switch intensive drying on or off . The set value is saved. ã=Warning At the end of the programme please open the door fully and not partially when emptying the dishwasher. Any escaping water vapour could damage sensitive worktops. Interrupting the programme ­ Switch off the main switch (. If the door was opened on an appliance which has a warm water connection or is heated, first leave the door ajar for several minutes and then close. Otherwise, expansion (pressure) may cause the appliance door to spring open or water to run out of the appliance. ­ To continue the programme, switch on the main switch ( again. Terminating the programme (Reset) ­ Only when the main switch is on: Rotate programme selector 8 to the Reset position. The digital display ` indicates after approx. [. . . ] ­ The appliance can easily be installed in a fitted kitchen between wooden and plastic walls. If the plug is not freely accessible, an allpole disconnector with a contact opening of at least 3 mm must be fitted on the installation side to satisfy the relevant safety instructions. 23 en Electrical connection ­ Connect the appliance only to 230 V and 50 Hz alternating current via a correctly installed socket with protective conductor. See rating plate for required fusing 9*. ­ The socket must be near the appliance and freely accessible following installation. [. . . ]