User manual PITSOS DVS5503

[. . . ] en Operating instructions 9000 510 601 (8906) Dishwasher 3 ABC 12 11 10 Reset 3 sec. 9 6 3 Program End Reset 3 sec. Start 1 2 3 4 5 678 9 20 21 22 23 24 25 26 27 28 29 30 31 32 en Table of contents Washing the dishes . Protection against frost (Emptying the appliance) . 15 15 15 15 16 16 16 16 16 17 17 17 17 17 18 18 19 19 20 20 21 21 22 23 23 23 24 24 24 24 25 25 25 25 26 26 26 Safety instructions . 7 Switching off water softening system . [. . . ] ­ Remove the utensils when they have cooled down. ã=Warning At the end of the programme please open the door fully and not partially when emptying the dishwasher. Any escaping water vapour could damage sensitive worktops. Interrupting the programme ­ Open the door. If the door was opened on an appliance which has a warm water connection or is heated, first leave the door ajar for several minutes and then close. Otherwise, expansion (pressure) may cause the appliance door to spring open or water to run out of the appliance. ­ To continue the programme, switch on the ON/OFF switch ( again. ­ Close the door. End of programme The programme has ended when the End display ` is lit. The end of the programme is also indicated by an acoustic signal. The buzzer volume can be set in 4 stages. Accordingly 0, 1, 2 or 3 displays are lit (see water hardness table). This function can be changed as follows: ­ Open the door. ­ Hold down button > P and press START button h until the End display ` and salt refill indicator )* flash. ­ Keep pressing button > P until the salt refill indicator )* and rinse aid refill indicator )" flash. The refill indicators )* and )" flash and the displays # and + are lit (= Setting 2). To change the setting, ­ Press the button < H until the required setting has been selected. ­ Close the door. Terminating the programme (Reset) ­ Open the door. The remaining programme sequence lasts approx. ­ Close the door. 16 en Changing the programme When the START button h has been pressed, the programme cannot be changed. The only way a programme can be changed is by Cancel programme (Reset). Maintenance and care A regular inspection and maintenance of your machine will help to prevent faults. This saves time and prevents problems. Intensive drying The final rinse uses a higher temperature which improves the drying result. (Caution if utensils are delicate!) ­ Open the door. ­ Hold down button > P and press START button h until the End display ` and salt refill indicator )* flash. ­ Keep pressing button > P until the salt refill indicator )* and "Check water supply" )2 flash. [. . . ] The displays of the last selected programme light up. ­ Select programme @ with the highest temperature button < H. The remaining programme sequence lasts approx. (Buzzer sounds. ) ­ Switch the appliance off ( and turn the tap off. [. . . ]