User manual PLANAR PR5020 QUICK START

[. . . ] Windows is a registered trademark of Microsoft, Inc. Other brand or product names are trademarks of their respective holders. Important Recycle Instructions: Lamp(s) inside this product contain mercury. This product may contain other electronic waste that can be hazardous if not disposed of properly. [. . . ] Open the OSD Status menu (menu only opens when input device detected) top/bottom) effect the OSD 20. Page up when connected through USB to a PC through USB to a PC through USB to a PC Caution: Overheating can damage the projector. Do not block any of the air vents around the unit. 3 2 IDENTIFY REMOTE CONTROL PARTS Remote Buttons Description 24. Enter key when connected 1. Lights when the remote control is used -- User's Guide -- Remote Buttons Description 26. Turn the projector on or off 5 2 MAKE CONNECTIONS 4 1. INSERT REMOTE CONTROL BATTERIES Remove the battery compartment cover by sliding the cover in the direction of the arrow. Insert the supplied batteries taking note of the polarity (+/-). Replace the cover. Warning: As a safety precaution, disconnect all power to the projector and connecting devices before making connections. Label Description Receiver for IR signal from remote control Connect the DVID cable from a computer (not supplied) Connect a VGA cable from a computer (supplied) Connect to a monitor (not supplied) Connect S-video cable from a video device (not supplied) Connect a composite video cable from a video device (supplied) Connect the audio cable from an audio input device (supplied) Connect the audio cable from an audio input device (supplied) Connect an audio cable from the computer's audioout connector (supplied) 2. 3. 1. Rear IR receiver DVI-D (For PR5020 only) VGA IN 2. 3. 4. VGA OUT 5. S-video 6. Video 7. Audio in-R 8. Audio in-L 9. Audio-in -- User's Guide -- Label Description Audio loop-thru Connect the USB cable from a computer (supplied) Installation control 10. 7. Press the Menu button and then press the cursor button until Tool is highlighted [D]. Press the cursor button until Language is highlighted [D]. Press the until your language is displayed. Press the Menu button twice to close the OSD. RS-232 12. (For PR5020 only) 13. Power Connect the power cord (supplied) Secure to permanent object with a Kensington® Lock system 14. Lock Security 7 1. ADJUST PROJECTOR LEVEL To raise the level of the projector, lift the projector [A] and press the height-adjuster button [B]. The height adjuster drops down [C]. 6 1. POWER ON/OFF AND SET LANGUAGE Connect the power cord to the projector [A] . Connect the other end to a wall outlet. Switch [B] from on (O) to off ( ) The POWER and READY LEDs on the projector turn on. [. . . ] You will also find troubleshooting procedures and instructions on securing the projector by means of a security lock. The projector has an On-Screen Display (OSD) that lets you make image adjustments and change various settings. To open the OSD, press the Menu button on the remote control. [. . . ]