User manual PLANTRONICS AWH-55

[. . . ] AWH54/AWH55 WIRELESS OFFICE HEADSET SYSTEM USER GUIDE OVERVIEW IMPORTANT SAFETY INFORMATION GENERAL When using your telephone equipment these basic safety precautions and warnings should be followed to reduce the risk of fire, electric shock, and injury to persons. · Read and follow all instructions and warnings and instructions prior to using the product. The symbol identifies and alerts the user to the presence of important operating, safety, and service instructions. · This product contains gold-plated nickel, phosphor bronze and copper. If you experience a skin irritation, discontinue use and contact Avaya. [. . . ] When in headset mode a warning alert of two beeps will sound in the headset shortly before you meet the range limit. On hearing this alert you should walk closer to the base unit to ensure call quality is maintained. If you remain out of range for more than 15 minutes the system will drop the call permanently. If using a Handset Lifter the handset will be replaced and the call terminated. Recharge the Headset To recharge the headset, place it into the charge cradle in the base unit. During charging, the charge indicator on the base unit will flash amber. When the headset is fully charged, the charge indicator on the base unit will stop flashing and remain illuminated. A completely depleted headset requires a minimum charge time of 1 hour before use, and 3 hours to fully charge. Low Battery Warning When the headset battery is running low (approximately 5 minutes talk time remaining), an audible warning will be heard through the headset as a single beep repeating every 10 seconds. ·When an optional lifter is connected, three repetitive beeps indicate a call is coming into the headset. Press the talk button on the headset to answer the call. 11 Callers cannot hear me. 13 I can hear beeps in the headset. 15 12 18 19 SYMPTOM I can hear too much echo or sidetone. SUGGESTION · Lower the speak volume fine tune (13) on the base unit. · If the volume is still too high, lower the speak volume master (12) setting. · Disable the IntelliStand function by moving the IntelliStand switch (10) to position I (off). · Replace battery with a new battery pack. If this does not work, try the subscription procedure on page 21. · Try to re-establish a link by pressing the headset talk button. If that does not work, try resetting the base unit. Last, try the whole System Reset procedure on page 22. SUBSCRIPTION The headset and base unit are supplied subscribed to each other. However, if you wish to use a replacement headset with the base unit, then the units must be re-subscribed as follows: 1. Return the headset to the headset charge cradle. Press and hold both the talk volume fine tune buttons on the base unit for a minimum of 5 seconds. The power indicator (3) will then flash (red). Press and hold the headset mute control button for a minimum of 5 seconds. The talk indicator light (17) on the headset will then illuminate (green). [. . . ] We recommend the installation of an AC surge arrester in the AC outlet to which this equipment is connected. Telephone companies report that electrical surges, typically lighting transients, are very destructive to customer terminal equipment connected to AC power sources. Caution: Users should not attempt to make such connection themselves, but should contact the appropriate electric inspection authority, or electrician, as appropriate. RSS 210 This digital apparatus does not exceed the Class B limit for radio noise emissions from digital apparatus set out in the Radio Interference Regulations of Industry Canada. Operation is subject to the following two conditions: 1) this device may not cause interference, and 2) this device must accept any interference, including interference that may cause undesired operation of the device. Accessing the Avaya Unified Communication Center (UCC) from the AWH54/AWH55 1. Connect the AWH54/AWH55 to the Avaya telephone. [. . . ]