User manual PLANTRONICS CA12CD/A

[. . . ] The base power indicator will illuminate. 1. 5 Slide the battery pack onto the remote unit. When the battery pack is installed or changed, the on-off Indicator will begin to flash slowly as soon as the unit is ready for use. [. . . ] · The remote unit's on-off indicator will turn on steadily (no flashing). · The remote unit will subscribe to the base unit, after which the base power indicator will return to the steadily on state. The remote unit's on-off indicator will go out for a few seconds and then begin to flash slowly. Your CA12CD/A is now ready to use. 3. 1 To maximise user density, always turn the remote unit off when not in use. 3. 2 Press the on-off button located on top of the remote unit. The green on-off indicator will begin to flash. If the battery has just been installed, the remote unit will automatically turn on and the on-off indicator will begin to flash. (Reference section 1. 5) 3. 3 Pressing the push-to-talk (PTT) button on the remote unit will generate the "key" signal to your console or radio. While the PTT button is depressed, the green talk indicator on the base unit will illuminate. 3. 4 The operation of the PTT button can be adjusted with a screwdriver to be either lockable or non-lockable as shown. How to select the lockable or nonlockable switch position Lockable position Note that the selector slot is aligned vertically. The push-to-talk button can be pressed momentarily or locked in the ON position by first depressing then sliding the button until it locks. Non-lockable position Turn the selector horizontally. The push-to-talk button can be pressed momentarily when you wish to speak. E ER TALK VOLUME Talk (sending) fine-adjust volume controls Listen (receiving) fine-adjust volume control CONTROLS AND INDICATORS Model CA12CD/A provides numerous audible and visible indications. Detailed descriptions are provided below. CONTROLS Name and Location Push-to-talk button on remote unit Locking-momentary selector on remote unit On-off button and indicator on remote unit Listen (receiving) fine-adjust volume control rocker switch on remote unit Listen (receiving) coarse-adjust volume control slide switch on base unit bottom Exposure to radio frequency radiation This device and its antenna must not be co-located or operated in conjunction with any other antenna or transmitter. To comply with RF exposure requirements, use only the supplied antenna. The radiated output power of this internal wireless radio is far below radio frequency exposure limits. Nevertheless, the wireless radio shall be used as described in the manual. The internal wireless radio operates within guidelines found in radio frequency safety standards and recommendations, which reflect the consensus of the scientific community. [. . . ] For more detailed information, please refer to our website www. plantronics. com ERROR CONDITIONS If you hear a. . . Triple beep Single beep every 10 seconds Low-level double beep every 10 seconds If you see a. . . Rapidly blinking remote on-off Indicator Rapidly blinking remote unit battery charging indicator It means. . . Your remote unit is too far from the base unit and you should move closer. Your battery is low and should be changed or charged. [. . . ]