User manual PLANTRONICS CA20

[. . . ] Charge for a minimum of 1 hour before first use. When charged: 1 When the remote is fully charged, the charge light (9) on the base stops flashing and is fully illuminated. 3) 1 2 3 4 Once the remote unit is fully charged, plug in your chosen Plantronics headset to the port (19). Re-dock your remote pack into the base unit. [. . . ] A third press will return the setting to `normal'. 7) 1 In order to switch between headset and handset use, simply depress the headset/handset switch (11). 8) It is ideal to stay inside the DECT range when using the CA20 Adapter, however, as you approach the limit of the DECT range, the following indication occurs: 1 The out of range warning lets you know that you are about to go beyond the useable range of the product. As you approach the range boundary, there will be 3 short warning beeps in the headset. Once you are out of range, there will be a short beep every 5 seconds, and the Ready/On-Line indicators on the base (17) and remote (17) units will turn off. any calls in progress will automatically be placed on hold. Once you move back into range, the warning beeps will stop, and the Ready/On-Line indicators will illuminate. 9) Low battery charge is indicated by warning tones through the headset as follows: a b c Approximately 15 minutes talktime remaining. 2 short beeps repeated every 30 seconds 5 minutes talktime remaining. 2 short beeps repeated every 20 seconds 1 minute talktime remaining. Charging the Battery Once you hear one of these indicators, you should recharge the remote pack by docking it in the base station. You can continue using the headset as normal while the remote unit's battery is charging. replacing the Battery The remote unit uses nickel metal hydride rechargeable batteries. After the batteries have been discharged many times, their performance may become degraded and you may notice a significant reduction in talktime performance when fully charged. When this occurs, the remote unit's battery pack will need replacing with a Plantronics replacement battery pack, part number 34592-01. Remove the battery compartment cover from the remote using the special tool. Dispose of the old battery pack safely, according to local regulations. You experience difficulties during registration Possible cause Ensure that the remote unit has not become registered with another base unit by removing and replacing the battery pack, and by un-plugging and re-plugging the base unit AC Adapter Plug You cannot hear or be heard Headset/handset button not engaged No power Push down headset/handset switch so that the coloured bar is visible above the switch Check: AC Adapter is connected to the base unit. check: AC Adapter is connected to the mains supply. Check: power indicator on the base unit is illuminated Check: headset is properly connected to the remote unit's headset port (19). Check: your telephone is connected to the base unit's telephone port. Check: handset is connected to the base unit's handset port (1) Try other configuration switch settings (20) on the base unit Listen for the warning beeps. [. . . ] Indien de verbinding tussen de mobiele unit en de basis unit succesvol tot stand is gebracht, zullen de `laad' indicatoren op de mobiele unit (17) en op de basis unit (17) binnen 60 seconden oplichten. De indicator zal knipperen op de mobiele unit (17) en constant zijn op de basis unit (17). Controleer of de mobiele unit niet bij een andere basis unit geregistreerd staat door de batterij te vervangen en door de AC Adapter stekker van de basis unit in-en uit te schakelen. Controleer of: ­ de AC Adapter is aangesloten op de basis unit ­ de AC Adapter zich in het stopcontact bevindt ­ de stroom indicator op de basis unit verlicht is Controleer of: ­ de headset correct is aangesloten op het aansluitpunt voor de headset (19) van de mobiele unit ­ de telefoon is aangesloten op het aansluitpunt voor de telefoon van de basis unit ­ de telefoonhoorn is aangesloten op het aansluitpunt voor de telfoonhoorn (1) van de basis unit Probeer een andere configuratie van de schakelaar instellingen (20) op de basis unit. [. . . ]