User manual PLANTRONICS DUOSET 2

[. . . ] 2 Fit both the foam ear cushion and the ear cushion holder onto the receiver. There are notches on the ear cushion which should be aligned with the boom. 3 Insert the ball joint of the headband into the socket on the back of the receiver. [. . . ] DECT&GSM Models If you are using a DECT or GSM telephone, plug the 2. 5mm connector into the headset port of the telephone or adapter. 1 Unsnap the headband from the back of the receiver. 2 Remove both the foam ear cushion and the moulded cushion holder from the receiver. 3 Press the pivot ball ring onto the headset, aligning it with the microphone boom. Insert the earhook into either the left or right hand side of the pivot ball ring, depending which ear the headset is to be worn on. 4 Place the headset over your ear as shown in the diagram and a&b gently press the receiver against your ear for a comfortable fit. Adjust the conformable earhook around your ear in order to obtain a comfortable fit. The headset cable can be slotted over the top of the earhook, for greater ease of use and comfort. 7 Clothing Clip The clothing clip helps to keep the headset free from the weight of the headset cable. Attach the clip to your clothing at a comfortable level. 8 Quick DisconnectTM Connector Some headset models are equipped with a Quick Disconnect Connector. When you separate the Quick Disconnect, you place an on-going conversation 'on hold' without removing the headset. Before using your headset, join the Quick Disconnect to the mating connector of your adapter cable. To put your call 'on hold', grasp the Quick Disconnect as shown, and pull straight apart. To resume your conversation, reconnect the two halves. [. . . ] Make sure that the receiver is correctly placed against your ear. Try adjusting the conformable earhook to suit your ear. GSM&DECT varianter Om du använder en GSM eller DECT telefon, anslut 2, 5mm pluggen antingen till telefonens headsetuttag eller till en adapter. [. . . ]