User manual PLANTRONICS MIRAGE

[. . . ] 1 Before you fit the headset onto your ear, move the receiver out as far as possible. Place the earhook over your ear and gently press the receiver against your ear so it is ideally positioned for comfort and call clarity. First it pivots at the metal ball joint, and secondly the voice tube can be telescoped in and out. [. . . ] 6 If you are using an M12 or E10 adapter there is a variable volume control. Start with setting 4, then increase or decrease the setting until you reach a comfortable listening volume. You can prevent a caller from hearing your voice by pressing the mute switch on the adapter. Voice contact can be retrieved by pressing the switch again. if you use an adapter please refer to the adapter user guide. If you do not have an adapter these features will be controlled by your telephone system. 7 The clothing clip keeps the headset properly positioned by supporting the weight of the cord. Attach the clothing clip comfortably at chest height, making sure there is enough slack to allow for head movement. 8 If you are wearing glasses you can use the glasses clip to help make the headset feel more stable. slip the clip onto your glasses and attach the headset to the clip. If you are wearing thinner metal frames, use the middle tab to help hold the clip in place. 9 Some headsets are fitted with a Quick Disconnect connector. Before you use your headset, join the adapter cable and the Quick Disconnect together. When you separate the Quick Disconnect, you put the ongoing conversation `on hold' without removing the headset. To do this, grasp the Quick Disconnect as shown and pull straight apart. To resume the call, reconnect the two halves. [. . . ] Refer to your adapter or telephone equipment user guide for guidance. Clean the headset and cable with a moist cloth once a month. If using a M12 amplifier, replace the batteries every six to nine months. [. . . ]