User manual PLANTRONICS SUPRAPLUS WIRELESS CS351N

[. . . ] This user guide provides instructions on the installation and usage of your system. Please read Safety Instructions and this User Guide before using your new headset. Please read the following instructions before use: General: · Use only the AC power adapter supplied. ⷠDo not use AC Adapter with any other equipment · The socket-outlet shall be installed near the equipment and shall be easily accessible · Use only the correct battery type ­ part number ­ 64327-01. [. . . ] Register your headset to your DECTTM telephone. to install the desk-charger simply connect to the AC Power Adapter. This will create the finished desk charger assembly. The headset must be charged for a minimum of 1 hour prior to use ­ 3 hours to fully charge. Prior to using your C351N headset for the first time, you MUST register(1) it with your DECTTM telephone. Before attempting to register the C351N headset, first read the instructions for registering a new DECTTM handset in the manual supplied with your DECTTM telephone. The process for registering the C351N headset will be very similar and the information below describes the registration sequence for a typical DECTTM telephone. Change the system Authentication code of your DECTTM telephone to 0000 to match the preset PIN of the C351N headset. Your DECTTM telephone manual will describe how to do this. Note: Many DECTTM telephones already use 0000 as their default Authentication code, so you may not need to change it. Place the DECTTM telephone base in subscription mode by following the instructions in your DECTTM telephone manual. Do not follow the DECTTM telephone manual instructions to place the handset in registration mode as this will register the handset rather than the headset. Complete registration by following any remaining instructions in your DECTTM telephone manual. Important: Your DECTTM telephone system must comply with the Generic Access Protocol (GAP) standard to work with the C351N headset. Modern DECTTM systems comply with the GAP specification, but some older systems may not. If in doubt, check the documentation supplied with your DECTTM telephone. Com which provides a list of compatible DECTTM telephone systems and provides detailed headset registration instructions for the most common models of DECTTM telephone. Ascending/descending tones 3 mid tones = Mute 3 low tones = Unmute NOTE: Tones repeat every 15 seconds when muted. [. . . ] Use fingernail to lift off and flip open battery door. Once battery is removed, gently disconnect battery connector; do not pull hard. Before replacing battery into compartment, please be sure battery wires are on side closest to opened battery door; the battery cannot be installed properly if wires are on other side. Using the "Y" end of the tool, press the battery backwards and away from battery door until the left corner of the battery tucks under the post in the battery compartment. [. . . ]