User manual PLANTRONICS VOYAGER 835

[. . . ] 3 Adjusting the Fit . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Wearing the Headset on Your Left Ear . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Headset Controls and Indicators. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Using More Than One Bluetooth Phone . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Use the commands on your phone to locate your headset. For most phones, select Settings/Tools > Connections > Bluetooth > Search > 8xxPlantronics. See your phone's user guide for more information. When prompted for the Pin code/Passkey, enter 0000. Pairing is successful when the indicator on your headset flashes blue and the headset emits a short low tone. Your headset is now connected and ready to use. In the US, you can see a demo of the pairing process at www. plantronics. com/EasyToPair. 3 4 3 Adjusting the Fit 1 2 Correct Fit 3 Incorrect Fit The headset comes out of the box with the earloop in place to wear on your right ear. 1 2 3 Place the earloop behind your ear. Rotate the headset so that the speaker rests comfortably in your ear. Align the microphone with the corner of your mouth. Callers can hear you best when you point the microphone towards the corner of your mouth. Wearing the Headset on Your Left Ear 1 2 Lift the earloop. Swivel the earloop to the right to wear it on your left ear. Adjust the headset as described above. 1 2 For right ear For left ear 4 Headset Controls and indicators Action Turn on the headset Turn off the headset Answer/end a call Press and hold the call control button for 2 seconds Press and hold the call control button for 4 seconds Tap the call control button Indicator Light Blue flash Tone Four rising tones Flashes red, then turns off Four falling tones Three blue flashes (repeating) Three brief repeating while phone is ringing. Blue low tone while ringing, flash every 2 seconds while then brief low tone at on a call. No indicator light beginning or end of when ending a call. the call None Three purple flashes (repeating) for 5 minutes, or until cancelled Blue flash every 2 seconds until the call is ended Long low tone None Reject a call Missed call Press and hold the call control button for 2 seconds Briefly press any button to cancel the indicator light. Enter the number on your phone and press send Make a call Brief tones, then ringing 5 Headset Controls and indicators Action Check battery power Press and hold both the call control and volume down buttons for about 2 seconds. The indicator light flashes red to show the charge level. Tap the up or down volume button Indicator Light red flashes Battery level 1 2 3 Blue flash More than 2/3 full 1/3 - 2/3 full Less than 1/3 full Brief low tone (2 low tones when volume limit is reached) Tone None Adjust the volume (during call) WARninG Do not use headsets at high volumes for an extended period of time. See www. plantronics. com/healthandsafety for more information on headsets and hearing. Voice Dial Redial last number Press and hold the call control button for 2 seconds Tap the call control button twice Blue flash repeating every 2 seconds Blue flash repeating every 2 seconds None Two brief low tones 6 Headset Controls and indicators Action Transfer a call from While the call is in progress, headset to phone, press and hold the call or from phone to control button for 2 seconds headset Enable/disable LED online indicator Press and hold both volume buttons for 3 seconds Indicator Light None Tone Brief low tone Fade in = Enabled Fade out = Disabled One brief low tone, 2 seconds of silence, then 2 brief low tones 7 Using More than one Bluetooth Phone Plantronics Voyager 835 supports multipoint technology, which allows you to use one headset with two different Bluetooth mobile phones. How to Enter Pairing Mode if Headset Was Paired Before While the headset is off, press and hold the call control button for 6 seconds. The indicator light will flash blue, then red/blue until paired. [. . . ] See "Adjusting the Fit" on page 4. Move the headset closer to the Bluetooth phone. Make sure that the headset is sitting correctly in your ear with the microphone pointing towards the corner of your mouth. See "Adjusting the Fit" on page 4. [. . . ]