User manual PLEXTOR 4PS-1

[. . . ] CD-ROM DRIVE PX-43CE Internal PX-45CE External Plextor reserves the right to make improvements in the products described in this manual at any time without prior notice. Plextor makes no representation or warranties with respect to the contents hereof and specifically disclaims any implied warranties of merchantability or fitness for any particular purpose. reserves the right to revise this manual and to make changes in its content without obligation to notify any person or organization of such revision or change. This manual is copyrighted, all rights reserved. [. . . ] Push button once during CD play mode to skip. Push and hold down play button more than one second to fast forward. Stop/Eject Button: Push to eject caddy. However, during Audio CD play mode, push once to stop audio play and twice to eject caddy. Emergency Eject Hole: Insert emergency eject stick, paper clip or other thin, rigid object to eject caddy if automatic eject button does not work. Turn off power before using this feature. PX-43CE/PX-45CE OPERATION MANUAL 9 CHAPTER 5 ---- Drive Features ON/BUSY Indicator: Yellow when power is on. Flashing when disc is inserted and being accessed. Off when disc is inserted and not being accessed. DISC Indicator: Green when power is on and disc is inserted. Off if no disc is inserted. Volume Control: Controls volume of headphone jack. This control has no effect on the rear panel audio outputs. 9 Headphone Jack: Stereo mini-jack for headphones and powered speakers. PX-43CE Internal Drive---REAR PANEL Audio Output Connector SCSI Interface Connector Jumpers Power Connector Audio Output Connector: Outputs stereo analog signal. Use to connect to soundboard or audio amplifier. SCSI Interface Connector: Connects to SCSI interface board using 50-pin to 50-pin flat ribbon SCSI cable. Jumpers: Use to select SCSI ID number, parity, term, test, block size and eject lock options. Leave these jumpers at their factory settings unless one or more of the following situations pertain to you: SCSI ID number: If you are using more than one SCSI peripheral, you may have to change your SCSI ID number. Block size: If you are working in a UNIX environment and want to boot from your CD-ROM drive, see page 17. Eject lock: If you work in an environment where you need to prevent others from easily removing a CD-ROM disc from your drive, see page 17. Power Connector: Connects to your computer's power supply (DC +5V and +12V). 10 PX-43CE/PX-45CE OPERATION MANUAL CHAPTER 5 ---- Drive Features PX-45CE External Drive----FRONT PANEL Door Closed Front Door Caddy Slot Emergency Eject Hole Volume Control ON/BUSY Indicator 9 Headphone Jack DISC Indicator Stop/Eject Button Audio CD Play Button Front Door: Open to insert caddy. Caddy Slot: Insert caddy after opening door. Emergency Eject Hole: Insert paper clip or other thin, rigid object to eject caddy if automatic eject button does not work. Turn off power before using this feature. Stop/Eject Button: Push to eject caddy. However, during Audio CD play mode, push once to stop audio play and twice to eject caddy. Audio CD Play Button: Push to put drive in Audio CD play mode. Push button once during CD play mode to skip. [. . . ] Check your device driver manual for instructions on how to issue a software eject command. Test Block Eject PX-43CE/PX-45CE OPERATION MANUAL 17 ---- CHAPTER 7 ---- Termination YOUR TASK: YOUR OBJECTIVE: YOUR METHOD: Find the location of the SCSI termination jumper or switch. Determine if you must disable the SCSI termination. Your drive was shipped with termination enabled. If necessary, remove termination jumper or turn off SCSI termination DIP switch by following instructions below. You must enable SCSI termination if the PX-43CE or PX-45CE is the only SCSI peripheral used with your computer. [. . . ]