User manual PLEXTOR PL-6P1

[. . . ] CD-ROM Drive Operation Manual PX-63CS Internal CD-ROM Drive PX-65CS External CD-ROM Drive FCC NOTICE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee interference will not occur in a particular installation. [. . . ] Do not insert a warped or cracked disc caddy into the drive. See Chapter 11 for tips on handling and cleaning CD-ROM discs. # Do not attempt to open the drive and service it yourself. Removing the cover may expose you to harmful electrical voltages or the laser beam. For your safety, entrust service to Plextor-authorized service personnel only. 8 PX-63CS/PX-65CS OPERATION MANUAL ---- CHAPTER 5 ---- Drive Features YOUR TASK: YOUR OBJECTIVE: Get to know your drive. Learn how to operate different features of the drive. Learn some terms that will be used elsewhere in the manual. Match the parts of your drive to the diagrams below. YOUR METHOD: PX-63CS Internal Drive----FRONT PANEL Door Closed Front Door Caddy Slot Audio CD Play Button Stop/Eject Button Volume Control 9 Headphone Jack Emergency Eject Hole ON/BUSY Indicator DISC IN Indicator Front Door: Open to insert caddy. Caddy Slot: Insert caddy after opening door. Audio CD Play Button: Push to put drive in Audio CD play mode. Push button once during CD play mode to skip. Push and hold down play button more than one second to fast forward. Stop/Eject Button: Push to eject caddy. However, during Audio CD play mode, push once to stop audio play and twice to eject caddy. Emergency Eject Hole: Insert emergency eject stick, paper clip or other thin, rigid object to eject caddy if automatic eject button does not work. Turn off power before using this feature. PX-63CS/PX-65CS OPERATION MANUAL 9 CHAPTER 5 ---- Drive Features ON/BUSY Indicator: Yellow when power is on. Flashing when disc is inserted and being accessed. Off when disc is inserted and not being accessed. DISC IN Indicator: Green when power is on and disc is inserted. Volume Control: Controls volume of headphone jack. This control has no effect on the rear panel audio outputs. 9 Headphone Jack: Stereo mini-jack for headphones and powered speakers. PX-63CS Internal Drive---REAR PANEL Audio Output Connector SCSI Interface Connector Jumpers Power Connector Audio Output Connector: Outputs stereo analog signal. Use to connect to soundboard or audio amplifier. SCSI Interface Connector: Connects to SCSI interface board using 50-pin to 50-pin flat ribbon SCSI cable. Jumpers: Use to select SCSI ID number, parity, term, test, block size and eject lock options. [. . . ] Check your device driver manual for instructions on how to issue a software eject command. Test Block Eject PX-63CS/PX-65CS OPERATION MANUAL 17 ---- CHAPTER 7 ---- Termination YOUR TASK: YOUR OBJECTIVE: YOUR METHOD: Find the location of the SCSI termination jumper or switch. Determine if you must disable the SCSI termination. Your drive was shipped with termination enabled. If necessary, remove termination jumper or turn off SCSI termination DIP switch by following instructions below. You must enable SCSI termination if the PX-63CS or PX-65CS is the only SCSI peripheral used with your computer. [. . . ]