User manual PLEXTOR PX-PA15AW HARDWARE

[. . . ] PX-PA15AW For Hardware Settings March 2006 Copyright © 2006 Plextor Corp. No portion of this document may be copied or reproduced in any manner without prior written permission from Plextor Corp. Plextor has no warranties to this documentation and disclaims any implied warranty of merchantability or fitness for a particular purpose. All information contained herein is subject to change without notice. [. . . ] Click Internet Protocol (TCP/IP) and change the IP address to a number between 192. 168. 168. 2 and 192. 168. 168. 254. Type 255. 255. 255. 0 for the Subnet mask. Example of an IP Address 2 Starting up the PX-PA15AW 3. Use your Internet browser to open http://192. 168. 168. 30/ to see the configuration page for the Receiver Box. Type "admin" as User name, and "1234" for Password. You must disable your firewall and proxy settings. If the configuration page doesn't open, turn the device off and on to reset it. 3 Setting up the PX-PA15AW Chapter 2 Setting up the PX-PA15AW The main menu has all the controls for configuring your PX-PA15AW. Status Under Status, you can view the current settings of the Ethernet LAN or WLAN. Click General and LAN to see the Device Information and LAN Settings, including the MAC and IP address. WLAN settings can be seen by clicking WLAN. · The Region setting will tell you if 802. 11a Ad-hoc mode is supported or not. For region ETSI, the 802. 11a 5 GHz Ad-hoc mode is not supported. · The Link Status may be Up, indicating that it is connected to a PX-PA15AW Sender, or Down, indicating that it is available for connecting. 4 Setting up the PX-PA15AW Setup Under Setup, you can choose LAN or WLAN. LAN is used to choose DHCP or static for the IP address. · If you select DHCP, you have to find the IP address by using another tool or by asking your MIS department if you ever need to reconfigure. An alternative would be to push and hold the Reset button on the Receiver Box for more than 5 seconds to revert to the factory default IP address. · If you change to another network segment, remember to configure the computer to the same network segment. 5 Setting up the PX-PA15AW Use WLAN to change these settings. · · Country is used to identify the WLAN card set. Region is used to identify the radio certification. · · SSID is defaulted to use "WMS100-IMAGE" Channel & Transmission rate is used to identify the transmission speed. [. . . ] You can press the Reset button for more than 5 seconds to get the default user name and password if you forget it. Only English alphanumeric characters are accepted for passwords. 7 Setting up the PX-PA15AW Download WMS Click to download the WMS software. The program will be installed immediately. Site Survey This function is used to connect to any other SSID groups, especially Access Point. 8 [. . . ]