User manual PLEXTOR PX-PA15AW SOFTWARE

[. . . ] It's all very easy to set up and the hard choices like channel and serial number selection are made automatically. If you buy more than two devices, the one-to-many transmission mode will not be supported for Ethernet connections. · · · · System Requirements Hardware Box Requirements Features Installation System Requirements Presto!WMS requires hardware in the form of a wireless card. Here is a list of the system requirements that must be met before installing the programs. [. . . ] WMS will automatically display any network devices. Click OK to start scanning for channels, and then scanning for the adapters. 4 Chapter2 Setting Up the System This scanning process only happens when (1) opening Presto!WMS the first time (2) the adapter has been modified. Presto!WMS will recognize the previously connected device when opening and skip the device scanning. If the previously connected device has been removed, a message will open and device scanning will be done again. For WLAN cards that have yet to pass the Windows certification, the scanning process won't find the adapter. This message will appear to help you find a solution: "WMS is unable to connect to the receiver with the Windows Standard Utility. To begin using the software, please use your Windows WLAN card utility to manually locate a wireless connection to the receiver". After you click OK, the main control panel will open. If you used the WLAN Card utility to manually locate a wireless connection to the receiver, you can start to play. Otherwise an adapter won't be found. " For Ethernet, the scanning process won't start and the main control panel will open. The scanned adapters will be shown on the Adapter List. Click one to select it. 5 Chapter2 Setting Up the System You can select more than one adapter. If Multiple Adapters is selected, there will be a check box for each device on the Adapter List. The selected adapters will receive the same source from Presto!Click the box. button on the control panel to open the Settings dialog 6 Chapter2 Setting Up the System 5. Click the Adapter tab and make the following settings. Serial Number: Shows the available adapters. Multiple Adapters: Enable this option to select more than one adapter for transmission. There won't be a check box in front of the listed adapters if this option is not enabled. Search: Click this button and the program will scan again for available adapters. 7 Chapter2 Setting Up the System If the network device is Ethernet or the WLAN card has not passed the Windows NDIS certification, the functions on the Adapter tab will be disabled. Click the Quality tab to set up the screen capture quality supported by Presto!WMS. Color Quality: Click to choose Best, Better, or Normal. [. . . ] Data is being transmitted between computers. Data is being transmitted between computers using the WEP key settings. A connection is being provided by the Access Point. A connection is being provided by the Access Point using the WEP key settings. [. . . ]