User manual PLUS V-339

[. . . ] DATA PROJECTOR V-339 User's Manual IMPORTANT * DLPTM (Digital Light Processing) and DMD (Digital Micromirror Device) are registered trademarks of Texas Instruments Incorporated (U. S. A. ). * VGA and XGA are trademarks or registered trademarks of International Business Machines Corporation (U. S. A. ). * S-VGA is a registered trademark of Video Electronics Standards Association. * Microsoft, Windows, and PowerPoint are registered trademarks of Microsoft Corporation (U. S. A. [. . . ] (1) Press the TIMER button to show the settings display. The display will close when an operation has not been made for about 10 seconds. STANDBY MENU (2) RGB ENTER CANCEL button (3) VIDEO CANCEL QUICK Q FREEZE MUTE ECO AUTO 1 2 3 4 ASPECT VOL KSTN ZOOM TIMER (1) [Timer settings display] Press the CANCEL button to close the display immediately. (2) Use the and SELECT buttons to set the time. The setting contents are "Off" and from 10 to 60 minutes (in 10-minute intervals) Settings can also be made with the SELECT ( ) buttons. (3) Press the ENTER button and start the timer. · The display of the timer setting will close, the display of the timer will appear and simultaneously the timer will start. Gauge (Blue) [Timer Display] The blue gauge indicates the remaining time. When the gauge disappears, the time is up. The gauge continues to be displayed when the timer is stopped. When the remaining time is "0" (Gray) · Press the ENTER button to restart the timer. The timer will start with the same time setting. · Press the CANCEL button to close the timer display. The timer setting will return to "Off". Moving the Position of the Timer Display The SELECT ( ) buttons on the remote control permit movement within the movable range of the timer display. Movable Range of the Timer Display Note: * The timer display will be closed while the menu or the quick menu is displayed, and while a message is displayed; however, the timer will still be operating at such times. Also, the timer will not be displayed unless a signal is being input. * While the presentation timer is being displayed, screen movement will not be possible in the zoom mode. E-29 General Operation Protecting the Projector with the Security Lock A password can be registered and the security lock set in order to protect the projector from unauthorized use. Registering the password The password is registered using the menus. For instructions on operating the menus, see "Menu Operation Method" on E-33. (1) Select "Security Lock" in the "Option" menu and set it to "Enable". The menu closes and the password registration display appears. (2) Use the number buttons (1 to 4) to register the password. Example: Registering the password "2441" (1) Press number button "2". An " " (asterisk) appears at the first place. Next press number buttons "4", "4" and "1" in that order. Asterisks appear in all four places. STANDBY MENU RGB ENTER * VIDEO CANCEL QUICK Q FREEZE MUTE ECO AUTO 1 2 3 4 ASPECT VOL KSTN ZOOM TIMER (2) Input the password again. [. . . ] · Do not remove any screws other than those specified. · Do not touch the lamp with bare hands. Doing so could shorten the life of the lamp. · If lamp has reached the end of its usable life, the lamp bulb may shatter. [. . . ]