User manual POCKETWIZARD LOW VOLTAGE TRIGGER-MINIPHONE

[. . . ] LVT-M Low Voltage Trigger -- Miniphone manufactured by LPA Design User's Manual LVT-M Operation Guide Purpose · Use with high voltage strobe packs and low voltage electronic triggering devices · Safely parallel different packs · Prevent damage to many cameras PocketWizard's Low Voltage Trigger makes working with high voltage strobes safe and reliable. Make your strobes compatible with more triggering devices and with each other. [. . . ] Place an "Add-A-Tap" (household female connector) to each point that you wish to connect an LVT. You can usually tell the polarity of the Zip cord from a small stripe or ridge that runs the length of the zip cord. Plug a household to miniphone cord into the Add-A-Taps the same way at each location. Batteries There is a battery inside the LVT. The battery should last for approximately 200, 000 shots of normal duration. If it becomes necessary to replace the battery, it may be returned to the factory for a new battery. The battery used is a Panasonic BR-2325-2HC. Your LVT is a rugged piece of equipment. However, to insure continued reliability, please follow these guidelines: · · · · Do not subject the unit to high mechanical shock (don't drop it!) Damage may occur to some components if the LVT is stored below -20°C (-4°F) or above +85°C (185°F). Do not connect any device to this unit unless that device is approved for use by PocketWizard. Connection to unapproved devices may cause damage and will void your warranty. To clean the LVT, use a lightly dampened cloth to wipe the exterior surfaces. [. . . ] If the pack still does not fire, make sure the cable going from the Pack to the LVT is OK. If the pack fires without the LVT attached, your pack may be incompatible with the LVT. [. . . ]