User manual POCKETWIZARD PLUS

[. . . ] Up to four photographers can operate their PocketWizard Plus remote triggers in the same space. The PocketWizard Plus is also compatible with older 10 and 16 channel PocketWizards. Basic Setup for Remote Flash NOTE: If you are trying to trigger a camera, See section TRIGGERING A REMOTE CAMERA on the next page. Install batteries or plug in the AC adapters 2. To connect the transmitter to the camera, you have two choices: (1) Slide the transmitter into the Hot Shoe. [. . . ] Move the LOCAL - BOTH - REMOTE selector switch on the transmitter to the LOCAL or BOTH 3. Press the shutter release button on your camera to activate the strobe. 3. Press the TEST button on the transmitter to activate the camera. Triggering Multiple Strobes With Multiple Receivers: If you need additional light sources, use several strobes, each with its own PocketWizard receiver. Remember, You can use your older PocketWizards as long as they are on the same channel. Connect the TO FLASH on each receiver to each strobe pack. Set all receivers to the same channel as your transmitter. Press the shutter release button on your camera (connected to the transmitter) to activate multiple strobes. Triggering a Remote Camera: WARNING: It is not possible to connect a remote flash and a camera to a receiver at the same time. Use a second pair of PocketWizards on a different channel or connect remote flash to sync-out (PC connector) on remote camera instead. Connect the PocketWizard Plus receiver to the motor drive port of the camera with a motor drive cord. Slide the CHANNEL switch to set the ID numbers. Make sure the receiver and transmitter are on the same channel. TROUBLE SHOOTING Follow the troubleshooting steps below in order before you refer to the table. Check the batteries in the transmitter and receiver. Make sure that both units are set to the same ID (channel) number Put the LOCAL - BOTH - REMOTE switch on the transmitter in the BOTH position.  The LED on · Double check the power the receiver doesn't blink Remote strobe doesn't fire when you press TEST button on Transmitter, but receiver light come on. Connect the pack to the To Flash jack on transmitter and press TEST. If the strobe works connected to the transmitter, the receiver needs repair. If the strobe doesn't work, replace the cable. If a new cable does not work, try a different model pack. Old packs may be incompatible because of very high sync voltage. even when the power is on. The LED on the is stuck on · · · · · · · · source Try new AA Alkaline batteries Send the unit in for repair Check for a stuck TEST button on the unit or on the transmitter Try unplugging the Sync In cord on the transmitter or removing from the shoe Send unit in for repair For a strobe: Make sure it is plugged into the "To Strobe" port For a camera: Make sure that the cord is plugged into the "To Camera" port Make sure you are using LPA manufactured cables SUSTAINING HIGH PERFORMANCE Sustaining long distance performance from your PocketWizard Plus depends on the orientation and position of the units. [. . . ] Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Consult the dealer or an experienced radio/TV technician for help. [. . . ]