User manual POLAROID 545I FILM HOLDER

[. . . ] Type 55 P/N panchromatic black and white film that produces both a positive print and a recoverable negative. high-speed panchromatic black and white film. Polacolor ER (Extended Range) color print film, balanced for daylight and electronic flash (5500°K). Type 57 Type 59 Polacolor PRO 64 color print film balanced for longer exposure times Tungsten with tungsten/halogen light sources (3200°K) Polapan 400 panchromatic black and white coaterless film for general-purpose photography. Polacolor PRO 100 color print film for studio and general-purpose photography; balanced for daylight and electronic flash (5500°K) English 6 Attach the holder to the camera Before use, open the roller cover and inspect the processing rollers. Clean them if necessary (see Cleaning the rollers). [. . . ] The film instructions contain full details. Temperature affects processing time; at lower temperatures, the time must be extended. 4 Remove the picture from the envelope: Grip both tabs with your thumbs as shown (12-k). Using moderate pressure, tear the envelope open all the way down to the metal cap (13). With your left thumb hold down the negative and thin paper mask, and with your right hand quickly lift off the print (14). With the exception of Type 55P/N film*, the negative serves no further purpose. * The Type 59 negative is used for Image Transfer. Avoid contact with the chemicals that remain on the negative. See Caution notice. English 8 Type 55P/N film only: Use your left thumb to hold down the negative. With your right hand, quickly peel away the print and thin paper mask (15). Pull hard, and the print and mask will separate completely from the negtive section and cap. Remove the mask from the print and discard the mask. Complete instructions on removing the negative from the envelope and preparing it for enlargement are in the film instructions. depressed throughout the 3 following procedure. 3 Hold the film holder in one hand with the opening in the film plane facing you. With the thumb of the other hand, gently push the film 4 envelope out as shown (17) until the metal cap is visible. Then grasp the end of the envelope and pull it out. To process the film, carefully reinsert the envelope into the film holder as when first loading, move the control arm to P, and 5 process it as described above. Disengage the hooks (19-m) at the ends of the rollers. The top roller will swing up to permit easy cleaning of the entire assembly (20). 4 Clean the rollers with a soft, lint-free cloth, dampened with water if necessary. Rotate the rollers as you clean and inspect them. Also clean the rubber light seal roller. Never scrape the rollers with anything metallic, nor with your fingernail. 5 Replace the top roller, engage the hooks, then snap the cover closed. Cleaning the rollers To remove instant film for later processing After exposure, reinsert the envelope; push it in very firmly to ensure that it engages the metal cap at the end of the negative. [. . . ] Damage resulting from normal wear, mishandling or accident will be promptly repaired at a reasonable charge. To make returns, pack the holder carefully in its original shipping carton or other sturdy container with plenty of padding and ship it prepaid to the nearest Polaroid Office. 4 To replace the back panel, insert the end of the panel under the lip of the roller cover (24-n), then lower the panel into position. 5 Hold the back panel in position, and replace the side clips (25). Metal cap and envelope misaligned: If mishandled, the envelope and the metal cap may become misaligned (26). [. . . ]