User manual POLAROID FCM-0710

[. . . ] 7" Under-the-Cabinet LCD TV FCM-0710 20060209 Important Safety Instructions CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of un-insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OF MOISTURE. POWER SUPPLY: Connect the supplied adapter to the side of the Under-the-Cabinet LCD TV in the slot marked "Power In". Plug the two-prong end of the power cord to an AC100-240V outlet. [. . . ] FM button Press to shift to FM signal input mode. AM button Press to shift to AM signal input mode. - 11 - Remote Control 5. AV Button Press to shift to external AV input mode. MENU /SET Button Press once to enter the PICTURE setup menu. Press twice to enter and exit from the timer setup menu. Press to memorize the station under AM/FM status. Keep the FM antenna as horizontal as possible after connection. When connecting the supplied AM loop antenna, connect two black cords to AM and ground jacks as shown below. OUT DOOR FM ANTENNA EARTH WIRE · · · If the FM reception is poor, use a 75 coaxial cable to connect system to an outdoor FM antenna as above. If you connect the system with outdoor FM antenna, you should earth the system in order to avoid lightning strike. Do not connect the earth wire to gas pipe to prevent gas explosion. - 14 - System Connections Connecting To the Power Adapter This unit is powered via the switching power adapter (supplied). See the below figure for details: 1. Connect the AC adapter to jack marked with "DC 12V IN" on the rear panel of the unit. 2. 3. Plug the two-prong end of the power cord to the grounded electrical socket. When not using the unit, turn off the power of the unit first, and then unplug the power supply to prevent malfunctions. - 15 - Radio Function Radio Function Operation Press the FM or AM button to enter FM or AM radio mode. Then press the SEEK+/button on the remote control or the SEEK+/- button or / / button on the front panel for about 1. 5 seconds to start searching forward/backward from the current frequency. Press the button again to stop searching. Radio frequency will be displayed on the display panel. The frequency range of FM is from 87. 5MHz to 107. 9 MHz, frequency range of AM is from 520 kHz to 1710 kHz. Fine Tuning Press the SEEK+/- button on the remote control or the / button on the front panel once to fine tune the frequency forward/backward under radio mode. Semi-memorizing radio stations If you like a radio station and want to store it for later listening, press the MENU/SET on the remote control or the SET button on the front panel to memorize it. "SAVE 00" will be displayed on the display panel, "00" represents the default station number. There are two methods to organize the memorized stations: · Use the buttons to adjust the channel number for your preference, and then press the MENU/SET button or SET button again, the station will be memorized with the coded station number. · Press the MENU/SET button or the SET button again, the station will be automatically memorized with the default station number in sequence. [. . . ] To reduce risk of fire, do not place any heating or cooking appliance beneath the unit, especially while the LCD screen is open for viewing. Mount the unit so that its AC power cord can be plugged directly to a wall outlet. Do not use a converter or extension cord. Be sure that the AC power cord has no slack when the unit is working, because the cord acts as an FM wire antenna. [. . . ]