User manual POLAROID ID 4 INSTANT ID SYSTEM

[. . . ] ID-4 Instant Identification System The numbers throughout the text refer to the pictures at the end of this guide. Introduction The Polaroid ID-4 System is designed to provide highly secure photo-identification cards. The system includes a camera, a laminator and a diecutter. These fit on the base, which contains the power supply. [. . . ] Test this by moving the plate from side to side; if it is inserted correctly, it should move only slightly. Fit the bottom of the plate into the holder so the bar pushes in the flat metal spring (21). Gently push in and downward until the plate snaps into place, under the upper lip of the spring and behind the two retainers. To remove the plate, push in on the flat metal spring with your fingertip or the eraser-end of a pencil (22). Load the film 1 Be sure that the film holder is in the UP (or LEFT) position, then open the door. Before loading the film, check that the developer rollers are clean (see Clean the developer rollers). 2 Always hold the film pack by the edges, not in the center. Slide the pack in at an angle, then push it down into place (23). 3 Check that the white tabs are not caught between the pack and the holder (24). 4 Close and latch the door, with the end of the black tab sticking out (25-S). The "Pull film tabs" indicator will light up. Page 2 5 Pull the black tab straight, all the way out of the holder (26). If not, see No white tab? Diecut the print 1 Insert the print into the diecutter as shown (38). Check that the ID pictures are properly centered left to right. 2 Push down on the handle to cut the print into two ID pictures (39). 3 Release the handle, then remove the scrap paper from the diecutter (40). Laminate the picture Most ID pictures will be sealed inside a plastic pouch for protection. Then pouches may be printed with additional information, or have a magnetic stripe or other security features. 1 Place the diecut picture inside the pouch (41). 2 Place the pouch inside the carrier, with the sealed side of the pouch against the closed side of the carrier (42). 3 Insert the carrier into the laminator (43). The rollers inside the laminator will start, and pull the carrier through. The carrier will come out through the slot in the back of the laminator. [. . . ] 3 Push the lever on the bottom of the camera to the left, and slide the camera into the "storage" position (55). 4 Unlatch the base and remove it from the cover. Place the base on a firm, level surface (56). 5 Wind the power cord around the cord holder as shown (57). [. . . ]