User manual POLAROID LWT TECHNICIANS GUIDE

[. . . ] If you have difficulty inserting the plug, turn it over and reinsert it. If the unit will not the used for a long time, disconnect the plug from the outlet. (For TVs with a built-in DVD player) NOTE: Before plugging the power cord into an AC outlet, make sure that all input and output device connections have been made. CAUTION: These servicing instructions are for use by qualified service personnel only. [. . . ] Apparatus shall not be exposed to dripping or splashing and no objects filled with liquids, such as vases, shall be placed on the apparatus. In the event that an electric shock is transmitted, the 7) 8) 9) 10) 11) 12) 13) 14) Note: Do not touch the LCD screen. screen could be damaged. Copyright Protection (For TVs with a built-in DVD player) This product incorporates copyright protection technology that is protected by U. S. patents and other intellectual property rights. Use of this copyright protection technology must be authorized by Macrovision, and is intended for home and other limited viewing uses only unless otherwise authorized by Macrovision. Reverse engineering or disassembly is prohibited. -3- Technician Setup This television is designed for commercial use and some settings can be controlled via the Technician's Menu. To access this menu and these settings, please follow the procedures below. Turn down the television volume to the minimum level. Use the number buttons to enter the PIN. The Technician's Menu will then appear as shown. Please consult your Polaroid sales representative for a PIN number. Within this menu, press the button to select item and press the or button to enter the setup menu; press the Exit button to exit the menu. Technician Setting Press the button to select Technician Setting and press the button to enter the setup menu. Within this menu, press the button to select items and press the Enter button to set. Press the Exit button to exit the menu. -4- Technician Setup (Continued) Application Mode Press the button to select Application Mode and press the Enter button to enter the select the application mode (VOD): NXTV, OnCommand, OnCommand/Enseo, HSI, No VOD, LodgeNet or LodgeNet/Enseo. Press the Exit button to exit the menu. Software Version Press the button to select Software Version and press the Enter button to display the software version information on the screen. Note: Software Version information will change after firmware updates. Reset Press the button to select Reset and press the Enter button to reset all the settings of technician menu to default status. Press the Exit button to exit the menu. -5- Enseo Set Top Box Operation Your TV may have come equipped with an optional Enseo set top box for hospitality Video on Demand (VOD) support. For models equipped with an Enseo set top box, please refer to the following. Enseo Set Top Box Installation: Refer to the figure and the steps below to install the Enseo set top box to the unit: 1. Open the back cover on the left rear panel of the unit. Carefully insert the bracket into the appropriately sized cavity on the back of the TV and lock it using the screws. Carefully insert the Enseo set top box into the appropriately sized cavity on the bracket and lock with the screws. Plug one end of the communication cord into the PPV jack on the Enseo set top box. [. . . ] Make sure the remote control is pointing at the television. Make sure the batteries are correctly installed in the remote control. There is no sound. There is no picture or picture moves up and down. The unit can't play discs. The unit does not continue to play discs or plays the same section repeatedly. The remote control does not work. Other Notes: Static electricity, lightning, power outages or brownouts and other external interference may cause the television to behave abnormally. Should this occur, unplug the television power cord from the outlet, wait 60 seconds, and then plug it in again to reset the unit. If the problem persists, then please disconnect the power and consult a qualified technician. [. . . ]