User manual POLAROID MACRO 3 SLR

[. . . ] The camera turns off if the power button is pressed again, or after 30 seconds of inactivity. (Note: The camera can also be turned on by lightly pressing the shutter button. The red LED blinks while the flash units are charging; the green lights will come on when Each film pack contains 10 sheets of film and a battery providing power. These high-speed (ISO640/29°) films are balanced for electronic flash and daylight (5500°K), and produce positive color prints. [. . . ] This film has a grid pattern which is created during manufacture. The grid pattern appears as an overlay on any picture taken with the film. the pattern consists of 17 vertical and 13 horizontal lines. To help you define location on the grid, the vertical lines are identified by letters across the top, and the horizontal lines are identified by numbers Front panel is parallel to the subject (13). Holding the camera at an angle (14) may cause uneven picture sharpness. If you wear eye glasses for distant viewing, Wear them when using the camera for accurate viewing and focusing. You can specify the location on the picture by a letter-number combination. Calculating measurement from the grid pattern When taking pictures at 1X magnification, each square of the grid pattern represents 5mm (0. The chart below shows the value represented by each square in pictures taken at each magnification. Very light subjects may require setting the control toward Darken. There may be bright ambient light affecting the exposure. Pictures too dark The camera may be too far from the subject for the selected magnification. the Lighten/Darken control may be set incorrectly. Very dark subjects may require setting the control toward Lighten. Subject not sharp The camera is at the wrong distance from the subject. (Pictures also will be incorrectly exposed -- too light or too dark. ) Portions of picture out of focus, or distorted subject The camera is not parallel to the subject. To remove dust or fingerprints, breathe on the lens and wipe it gently with a clean, soft facial tissue. [. . . ] This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus set out in the Radio Interference Regulations of the Canadian Department of Communications. This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: If the exact magnification must be documented, include a scale in the picture (18). The scale and the subject must be at the same distance from the camera. [. . . ]