User manual POLK AUDIO DR-3 LEARNING REMOTE

[. . . ] UNIFIED LEARNING REMOTE CONTROL DR-3 INSTRUCTION MANUAL Table of Contents INTRODUCTION The Polk Audio DR-3 Unified Learning Remote was designed to operate the Polk Audio Digital Solution home theater system and Polk Audio DP-1 CD/DVD player. It can also be programmed to operate most DVD and CD players, TVs, Cable and DSS tuners as well as VCRs. By following the easy steps in this manual, you can reduce or eliminate the need for having several remote controls on your coffee table. As nifty as it may be, the DR-3 unified remote cannot duplicate every function of every remote control without turning it into a nightmare of tiny buttons. [. . . ] Press and hold the SAVE button for 2 seconds to store the threedigit number. The Status light and the Source/Device button light will blink twice to confirm that the code has been stored, and then turn off. Try all the functions on the remote control. NOTE: If any of the functions do not work as they should, repeat the programming process using the next three-digit code number assigned to your brand. If only one or two buttons don't work right, it may be easier to individually "teach" the DR-3 those commands (see page 9) or use the Auto Search method (see page 8) rather than trying all the three-digit codes. 4 5 3 6 www. polkaudio. com 7 PROGRAMMING THE REMOTE Auto Search Method If none of the three-digit code numbers assigned to your brand shut off your equipment or if your brand of equipment is not listed in the code tables, you can use the Auto Search Method to find the correct threedigit number for your equipment. Turn on the equipment you wish to program. NOTE: From here on in you have 20 seconds to perform each step. If the Source/Device button light goes off, you need to back up a step and do it again. You can exit the set-up mode by pressing the CNCL (cancel) button at any time in the process. Press and hold the CODE button for two seconds. The red status light at the top left of the remote will turn on. Press the Source/Device button you wish to program (e. g. The Source/Device button light will turn on. Press and hold the CH UP or CH DOWN button. The remote will emit a series of Power On/OFF code signals that are stored in its memory. Release the CH button as soon as the equipment turns off. You can verify that you have chosen the correct code by pressing the SOURCE POWER button, the device should turn On and Off. The status light and the Source/Device button will blink. Press and hold the SAVE button for two seconds to store the code. The status light and the Source/Device button light will blink twice and then turn off to confirm that the code has been stored. Note: You can verify that you have chosen the correct code by pressing the SOURCE POWER button, the device should turn On and Off. The status light and the Source/Device button will blink. 2 4 3 4 5 Finding the Three-Digit Code Number for a Device If you are curious which three-digit code was auto-assigned to a given Source button follow these steps: 1. [. . . ] If the Source button light goes off, you need to back up a step and do it again. You can exit the set-up mode by pressing the CNCL (cancel) button at any time in the process. Press and hold the CODE button for two seconds. The status light at the top left of the remote will turn red. [. . . ]