User manual POLK AUDIO LCI-RTS100

[. . . ] Use at least 14 gauge wire or heavier for the best sound quality. (Note: Wiring is best performed by an experienced professional. ) When installing your LCi Series In-ceiling Loudspeakers, be aware of the weight of your particular model (see specification page for the weight of your model) and the sturdiness of the material into which you are installing the speaker. Be aware of any concealed studs, electrical wiring or plumbing in the wall or ceiling into which you are installing the speakers. [. . . ] PAINTING IN-CEILING GRILLES Painting in-ceiling grilles The LCi-RTS100 is supplied with two grilles, one perforated aluminum, the other cloth-covered plastic. The perforated aluminum grille may be painted, while you may dye the cloth grille. Paint of your choice (grilles must be spray painted). If the speaker is not yet installed, the grille can be removed simply by pushing the clamp screws forward to push the grille off the speaker from the inside. Remove the cloth scrim from the inside of the grill. When painting the speaker frame, use the supplied paint masks to carefully mask off the front of the speakers to protect the drivers and baffles. You can do this while the speaker is already installed in the ceiling (if, for instance, you're repainting the room). If you do not have the paint masks, carefully mask the speaker components using paper and masking tape. If you're using a compressor and spray gun, use the finest, most diffused setting. Be careful not to fill the holes in the grille with paint. When the paint is completely dry, carefully reinstall the grille by fitting it into its recess so that it is just resting on the frame. Starting with one corner, go around the speaker and push the grille into the grille notch a little bit at a time. Be gentle; the grille may be easily bent by rough handling. You will feel a positive "snap" when the grille is fully in place. When the paint is completely dry, remove the masking material. Important note: The RTS100 comes with an eye-bolt, which must be installed before locating the speaker in a ceiling. Use an appropriate length and weight of wire when installing an RTS100 in a ceiling. For more information visit our website at www. For more information visit our website at www. For more information visit our website at www. For more information visit our website at www. For more information visit our website at www. [. . . ] Or a Polk Audio Authorized Dealer has been advised of the possibility of such damages, or for any claim by any other party. Some states do not allow the exclusion or limitation of consequential damages, so the above limitation and exclusion may not apply to you. All implied warranties on this Product are limited to the duration of this expressed Warranty. Some states do not allow limitation on how long an implied Warranty lasts, so the above limitations may not apply to you. [. . . ]