User manual POLK AUDIO MM461P

[. . . ] Having that extra power is good for on-ramp acceleration and danger avoidance (like getting away from brain-eating zombies) but that doesn't mean that it is advisable to operate your car on North American highways at full power and maximum speed for an extended period of time. Just ask your local state trooper if you are in doubt. Similarly, we recommend using amplifiers and receivers with rated power above the Power Handling limits of our speakers because having extra power available for short term peaks is conducive to better sound quality, maximum dynamic range and effortless high volume output. But we strongly urge you not to use the full power of your amplifier or receiver for daily listening. [. . . ] ABSTANDSRING-ADAPTER (nur für die MM651/MM6501Treiber-Installation) STAFFA DI ADATTAMENTO/DISTANZIATRICE (solo per l'installazione del driver MM651/MM6501) ESPAÇADOR/SUPORTE ADAPTADOR (apenas para instalação dos modelos MM651/MM6501) Figure 10 TWEETER ATTENUATION SWITCH A 2-position switch (-3dB, 0dB) allows you to adjust tweeter level for the tonal balance that's right for your car and system. Mark the center of the hole you want to cut. 8mm) diameter hole using a hole saw, drill bit or razor knife. Note: The cup and spring clamp come preassembled as a single unit. Route wires through the cutout and then through the round opening in the bottom of the cup. Press the flush cup/spring clamp assembly into the cutout until the spring clamp arm's snap into place. Connect wires from the tweeter terminals for the crossover to the tweeter itself using the faston connectors. Connect the red wire from the (+) positive terminal of the crossover tweeter output to the red positive (+) wire from the tweeter. Using the base of the surface mount cup as a template, mark the screw hole and drill them using a 1/8" (3mm) drill bit. Drill a second hole (for the speaker wire) using a 3/16" (5mm) drill bit. Push the tweeter wires through the open area at the bottom of the cup and through the 3/16" (5mm) hole in the panel. Connect wires from the tweeter terminals of the Crossover to the tweeter wires using faston connectors. Be sure to connect the red wire strand from the tweeter to the (+) terminal of the crossover tweeter output. Polk Audio loudspeakers and subwoofers are capable of playing at extremely high volume levels, which could cause serious or permanent hearing damage. Accepts no liability for hearing loss, bodily injury or property damage resulting from the misuse of its products. Keep these guidelines in mind and always use your own good judgment when controlling volume: · High volume in an automobile can hinder your ability to safely operate a vehicle. You are responsible for knowing the local laws governing acceptable mobile volume levels. Html Product Disposal - Certain international, national and/or local laws and/or regulations may apply regarding the disposal of this product. [. . . ] This Warranty does not include service or parts to repair damage caused by accident, disaster, misuse, abuse, negligence, inadequate packing or shipping procedures, commercial use, voltage inputs in excess of the rated maximum of the unit, cosmetic appearance of the cabinetry not directly attributable to defects in materials or workmanship, or service, repair, or modifications of the Product which has not been authorized or approved by Polk Audio. This Warranty is in lieu of all other expressed Warranties. If this Product is defective in materials and workmanship as warranted above, your sole remedy shall be repair or replacement as provided above. Be liable to you for any incidental or consequential damages arising out of the use or inability to use the Product, even if Polk Audio, Inc. [. . . ]