User manual POLK AUDIO POLKMOMO SYSTEMS

[. . . ] Dear Music Lover, You have just entered a new realm of car audio!I am extremely excited about these Polk Audio/MOMO high performance speakers; this is the first time that the exclusive MOMO Design house of Italy has co-branded a product. We've partnered with them to produce the best sounding, best looking car speakers ever. They are going to make your car look and sound great. [. . . ] Tighten the thumbnuts finger-tight (do not over-tighten the nuts as you may strip the threads). Be sure to attach the wire with the white stripe to the positive (red) terminal, and the un-striped wire to the negative (black) terminal. If the factory speaker had three screw holes, you'll need to drill additional screw holes to accommodate the four screw pattern of the Polk/MOMO mid/woofer. Using the hardware retained from the factory speaker or the screw clips supplied with the Polk/MOMO speaker, secure your new speaker to the car panel. If you have decided to install your Polk/MOMO Series mid/woofers in locations other than those provided by the automobile manufacturer, make certain that the location you choose is clear of all obstructions, both in front of and behind the panel, before you proceed. Pay particular attention to window mechanisms and any body panels critical to the structural integrity of the vehicle. The mounting depths and cutout diameters of your Polk/MOMO Series mid/woofers are listed with all the other important specifications at the end of this manual. Use the speaker grille as a template for marking the locations of the four screw holes. Cut the supplied driver wire (the heavier gauge of the two sets of wire) in half. Remove the yellow crossover cover by squeezing the cover at the tabs. attach speaker wires to the crossover "woofer" terminals. Attach the wire with the white stripe to the positive (+) terminal screw, and the un-striped wire to the negative (-) terminal screw. Route the driver wire from the crossover location through grommets to the mid/woofer location. Strip 1/8" ­ 1/4" (4-6 mm) of plastic insulation from the cut ends of the driver wire. Unscrew the binding post thumbnuts on the mid/woofers to fully expose the hole in the terminal shaft and slip the other end of the wire into the holes in the input terminals. Tighten the thumb nuts fingertight (do not over-tighten the nuts as you may strip the threads). Be sure to attach the wire with the white stripe to the positive (red) terminal, and the unstriped wire to the negative (black) terminal. Place the grille over the driver and line up the screw holes with the screw clips on the car panel. Secure the speaker/grille assembly to the car panel with the supplied Allen head screws. Using the base of the surface mount cup as a template, mark the screw hole and drill it using a 1/8 inch drill bit. mark the wire holes (for the tweeter wires) , drill using the 1/4-inch drill bit. Attach the surface mount cup to the panel using supplied #4 screw. [. . . ] A listing of Polk Audio Importer/ Distributors can be found on the Polk Audio website www. Warrants the original purchaser only that this Polk Audio Polk/MOMO Product (the Product) will be free from defects in materials and workmanship for a period of (3) three years from the date of original retail purchase from a Polk Audio Authorized Dealer. However, this warranty will automatically terminate prior to the expiration of the (3) three year period if the original retail purchaser sells or otherwise transfers the Product to any other party. The original retail purchaser shall herein after be referred to as "you. [. . . ]