User manual POLYCOM SOUNDSTATION 2W

[. . . ] SoundStation2WTM USER GUIDE / ADMINISTRATOR GUIDE User Guide and Administrator Guide IMPORTANT SAFETY INSTRUCTIONS When using your telephone equipment, the following safety precautions should always be followed to reduce the risk of fire, electric shock, and injury to people. · Read and understand all instructions. · Follow all warnings and instructions marked on the equipment. · Installation must be performed in accordance with all national wiring rules. [. . . ] If you want to fully turn the unit off, unplug the battery. While in Standby mode, the LCD display will still show estimated remaining talk time. Talk time is shown numerically in hours to the right of the battery icon. The console will switch into Standby, even if it is not registerd to the base station. For example, if you travel with the phone to a remote location without the base station, the console will switch into Standby to conserve power. The console will automatically reregister to its base station from Standby mode, if it is within range and the base station is powered. In some cases, the phone will not go into Standby mode when a mobile phone is plugged in, even if the mobile phone is not in an active call. In these cases the LCD message will continue to say "Mobile Phone In". Either turn off the mobile phone, or unplug it from the console to enable Standby. The phone will not go into Standby while charging. SoundStation2WTM User Guide - 22 Charging SoundStation2WTM operates on a rechargeable lithium ion battery. The battery needs to be recharged periodically. Use the supplied charger to recharge the battery while it is installed in the console. In similar fashion to a laptop PC or a mobile phone, the SoundStation2WTM can be used or continue operation while being charged. The battery cannot be recharged outside the console. Typical talk time and standby time are shown here: 2 cell battery Charge Time Talk Time Standby Time 4 hours 12 hours 80 hours 4 cell battery 8 hours 24 hours 160 hours Battery icon displayed on LCD. Charging State The SoundStation2WTM's display will indicate when the battery is charging by animating the battery icon. Low Power The SoundStation2WTM's display will indicate when battery charge is low. The low battery warning will begin when the remaining talk time is approximately 20% or less of the full charge capacity. The warning will be triggered when a user goes back on-hook after completing a call. This ensures that the low power warning is seen by a user. In addition to a visual message on the console LCD which will read, "Low Battery, Please Charge, " you will hear an audible beeping alert. Optimum battery performance may be achieved only after the battery is conditioned. The battery will have to go through four to five charge and discharge cycles before reaching optimum performance. Talk time is measured for natural conversation at optimum volume levels. SoundStation2WTM User Guide - 23 Auxiliary Audio Output SoundStation2WTM allows the speaker output to be routed to an external recording device. [. . . ] vakuuttaa täten, että SoundStation2W on direktiivin 1999/5/EC keskeisten vaatimusten ja sen muiden tätä koskevien säännösten mukainen. Déclaration de conformité : Par la présente, Polycom Ltd. déclare que ce SoundStation2W est conforme aux conditions essentielles et à toute autre modalité pertinente de la Directive 1999/5/CE. Dichiarazione di conformità: Con la presente Polycom Ltd. [. . . ]