User manual PORT DESIGNS MANHATTAN BF CLAMSHELL BROCHURE

[. . . ] Go to " Will Not Unlock" Troubleshooting Section. 2 LO 2 3 nF 3 When the filling Continues for Go to " No Water Fill" more than 40 minutes or there is no Troubleshooting Section. Go to " Will Not Lock" Troubleshooting Section. 4 FL 4 5 LE 8 A water level lower than the Reset water level (25. 6Khz) is detected for Go to "No Water Fill" 5 seconds during the Wash/Rinse Troubleshooting Section. (When the input signal from the water level Go to "No Water Fill" sensor is out of range, the unit will Troubleshooting Section send out beeping sounds and halts the cycle. ) A fault is detected in the water level sensor. Data (frequency) shows the water level is at or above the First check to see that all of water overflow water level. [. . . ] - WASH mode continues up to five (5) minutes once started. After the five (5) minutes have elapsed, "- - - -" is displayed on the 7 segment display and the initial Demo mode is maintained. - If the Start/Pause button is pressed during a WASH mode operation, "- - - -" is displayed on the 7 segment display and the initial Demo mode is maintained. - If the Spin button is pressed in the initial Demo mode, "Spin" blinks on the 7 segment display and the washing machine enters SPIN mode. - If the Start/Pause button is pressed in the SPIN mode, the door is locked (Door Lock) and a spin is operated at 1150 RPM. When the speed reaches 0 RPM, the No Spin, Low, Medium, High, and Extra High LEDs are turned on. - During a spin operation, the No Spin LED turns on when the speed is lower than 400 RPM. The Low LED turns on between 400 RPM and 800 RPM. The Medium LED turns on between 800 RPM and 1000 RPM. The High LED turns on at higher than 1000 RPM. - SPIN mode continues up to four (4) minutes once started. Leaking · Make sure inlet hose connections are not leaking. Check for rubber gasket damage due to over tightening. Wrap a dry rag around the standpipe opening. If rag becomes wet, leak is fault of home plumbing. Be sure the standpipe is capable of accepting the flow of water from the washer. · Make sure end of drain hose is correctly inserted and secured to drain standpipe. · Check internal hose connections (fill, drain systems, dispenser hoses & clamps). Remove, reposition and reinstall, if necessary. · Check for possible kinked dispenser to outer tub hose. Hot water pressurization may force door open. No Tumble · Start normal cycle with an empty machine and allow a fill to check tumble. [. . . ] · Go to Quick Test Mode and do Drain Pump Test. · Check if there is any twist in the hose (the one between Tub and Drain Pump). · Check if it reads AC 120V at the pump when a spin cycle is selected. · Read the winding resistance of the pump motor. [. . . ]