User manual POULAN PRO PP12TEPH30

[. . . ] IMPORTANT MANUAL Do Not Throw Away OWNER'S MANUAL MODEL NUMBER: SNOW THROWER PP13TEPH30 Read the Owner's Manual and follow all Warnings and Safety Instructions. Failure to do so can result in serious injury. WARNING: Always Wear Eye Protection During Operation 416751 Rev 1 09. 26. 07 TH Printed in U. S. A. Safe Operation Practices for Walk-Behind Snow Throwers This snow thrower is capable of amputating hands and feet and throwing objects. Failure to observe the following safety instructions could result in serious injury. Look for this symbol to point out important safety precautions. [. . . ] WARNING: Do not use the electric starter if your house is not a 120 Volt A. C. Serious personal injury or damage to your snow thrower could result. Insert safety ignition key (packed separately in parts bag) into ignition slot until it clicks. Keep the extra safety ignition key in a safe place. Place throttle control in "FAST" position. Rotate choke control to "FULL position. Plug the other end of the power cord into a three-hole grounded 120 Volt A. C. Push starter button until engine starts. IMPORTANT: Do not crank engine more than five continuous seconds between each time you try to start. Wait 5 to 10 seconds between each attempt. When the engine starts, release the starter button and slowly move the choke control to the "OFF" position. Disconnect the power cord from the receptacle first, then from the engine. Allow the engine to warm up for a few minutes. Engine will not develop full power until it has reached normal operating temperature. WARM START - ELECTRIC STARTER Follow the steps above, keeping the choke control in the "OFF" position. Insert safety ignition key (packed separately in parts bag) into ignition slot until it clicks. Keep the extra safety ignition key in a safe place. Place throttle control in "FAST" position. Rotate choke control to "FULL position. Push the primer four (4) times if the temperature is below 15°F, or two (2) times if temperature is between 15° and 50°F. If temperature is above 50°F, priming is not necessary. 13 NOTE: Over priming may cause flooding, preventing the engine from starting. [. . . ] Failure to do so could be hazardous, damage your snow thrower and void your warranty. 29 REPAIR PARTS SNOW THROWER - MODEL PP13TEPH30 (96198000901) WHEELS / DECALS 10 18 32 30 15 19 12 5 6 11 2 3 4 10 18 32 30 16 19 26 25 5 6 12 10 11 20 22 21 33 24 23 3 4 15 13 20 13 9 7 14 4 17 10 22 4 1 2 14 21 33 24 23 27 8 7 31 25 26 28 28 27 9 8 1 2 4 6 1 3 30 5 10 7 REPAIR PARTS SNOW THROWER - MODEL PP13TEPH30 (96198000901) WHEELS / DECALS KEY PART NO. DESCRIPTION 1 2 3 4 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 30 31 32 33 196752X421 155443 405161 184471 17000616 185603X479 185602X004 17600406 17490508 405077 193506X479 182015 194944X008 194939X008 194943X008 181847 85179 179148X479 192126 182466 187622 194941 179139 194940 189282 174697 193885 196753X421 700279 12000045 Wheel Assembly, 16", with Power Steering, LH Pin, Klik 1/4 Cover, Power Steering Screw, Shoulder, Hex Head #10-24 x 1/2 Screw, Hex Head 3/8-16 x 1 Bracket, Steering Cable, RH Bracket, Steering Cable, LH Screw, Cap, Hex Head 5/16-18 x 3/4 Screw, Hex Head 5/16-18 x 1/2 Link, Steering Lever Lever Assembly, Steering Pin, Steering Lever Bellcrank Bracket Assembly, LH Steering Bracket Assembly, RH Steering Pin, Steering Bellcrank Retainer, Hairpin Bracket, Lever Assembly Driver, Wheel Ring, Wire Retainer Lobe, Wheel Slide, Clutch Spring, Clutch Slide Lobe, Axle Key, Square 1/4 x 1/4 x 7/8 Washer, Thrust (1") Spring, Return, Steering Latch Wheel Assembly, 16", with Power Steering, RH Clip, Retainer Ring, Retaining KEY PART NO. NO. DESCRIPTION 1 2 3 4 5 6 7 8 9 10 --- 181037 416837 181035 181042 406989 181033 415399 415398 415475 183730 416751 416752 Decal, Danger Decal, Poulan Pro, 13. 0 / 30" Decal, Danger, Deflector Decal, Danger Decal, Poulan Pro Decal, Instruction Decal, LH Trigger Decal, RH Trigger Decal, Speed Control Decal, Remote Deflector Owner's Manual, English Owner's Manual, French NOTE: All component dimensions given in U. S. [. . . ]